User Manual

ManualsBrandsYamaha Manualscar media receiversR-N500

Firmware Update Procedure for R-N500

IMPORTANT NOTICE

Follow the instructions carefully and do not attempt any other procedures not specified in the instructions

provided by Yamaha.

Improperly updated products may cause improper operation, and any parts or service required to restore

proper operation will not be covered under the Yamaha Limited Warranty.

Choose from the following 2 methods to update to the latest firmware.

Click here for Firmware Update Through the Internet

(Connection to the Internet is required)

Click here for Firmware Update by USB

(A USB thumb drive is required)

In case of error, see the Troubleshooting section

[ 1. Firmware Update Through the Internet ]

Requirements:

Your R-N500 is connected to the Internet if you can receive

Internet radio stations. (See owner’s manual for details)

STEP 1 Turn off the unit.

STEP 2 While holding down RETURN on the front panel, press power.

STEP 3 “ADVANCED SETUP” will be shown for seconds.

STEP 4 Rotate SELECT/ENTER to select firmware update mode as shown below.

RETURN

SELECT/ENTER

POWE

DISPLAY

DIMMER

Summary of content (4 pages)

PAGE 1
Firmware Update Procedure for R-N500 IMPORTANT NOTICE Follow the instructions carefully and do not attempt any other procedures not specified in the instructions provided by Yamaha. Improperly updated products may cause improper operation, and any parts or service required to restore proper operation will not be covered under the Yamaha Limited Warranty. Choose from the following 2 methods to update to the latest firmware.
PAGE 2
Firmware Update Procedure for R-N500 STEP 5 Press SELECT/ENTER repeatedly to select “NETWORK” STEP 6 Press DISPLAY to start the update. (One screen shot during update process.) Update is completed when “UPDATE SUCCESS”, “PLEASE…”, “POWER OFF!” is displayed alternately. Then, power off the unit. note: DO NOT interrupt the power or press any buttons during the update. In case the power is accidentally cut off, the R-N500 will restore original firmware. Perform the update procedure from STEP 1 again.
PAGE 3
Firmware Update Procedure for R-N500 DIMMER DISPLAY RETURN POWER SELECT/ENTER STEP 1 Turn off the unit. STEP 2 Insert the USB thumb drive on the front panel. STEP 3 While holding down RETURN on the front panel, press power. STEP 4 “ADVANCED SETUP” will be shown for seconds. STEP 5 Rotate SELECT/ENTER to select firmware update mode as shown below. STEP 6 Press DISPLAY to start the update. (One screen shot during update process.
PAGE 4
Firmware Update Procedure for R-N500 note: DO NOT interrupt the power or press any buttons during the update. In case the power is accidentally cut off, the R-N500 will restore original firmware. Perform the update procedure from STEP 1 again. STEP 7 Confirm updated firmware version Retry from STEP 2 to enter “ADVANCED MODE”. Rotate SELECT/ENTER to select firmware version. Confirm that the firmware version has been updated. X.XX (X.XX shows actual firmware version.