POWER AMPLIFIER PC Series Remote Control Protocol Specifications Version 1.0.2 rev1 This specification document applies to V1.0.2 and later.
1. Device Control [Usage Example] To get device run mode devstatus runmode ↓ OK devstatus runmode "normal" Notification on Device run mode change NOTIFY devstatus runmode "update" To change keepalive setting To get product name scpmode keepalive 10000 ↓ OK scpmode keepalive 10000 devinfo productname ↓ OK devinfo productname "PC406-DI" Case No.
2. Parameter Control [Usage Example] To change device parameter value To get device parameter value Notification on parameter value change No. set AMP:Ch/Volume 2 0 -4000 ↓ OK set AMP:Ch/Volume 2 0 -4000 "-40.00dB" get AMP:Ch/Volume 2 0 ↓ OK AMP:Ch/Volume 2 0 -4000 NOTIFY set AMP:Ch/Volume 2 0 -4000 "-40.
No.
No.
3. Meter Control [Usage Example] To start meter data transmission mtrstart AMP:AnalogIn/Level 50 ↓ OK mtrstart AMP:AnalogIn/Level To stop meter data transmission mtrstop AMP:AnalogIn/Level ↓ OK mtrstop AMP:AnalogIn/Level Meter data periodically sent from device No.
4. AMP Preset Control [Usage Example] Request of current preset number sscurrent_ex ↓ OK sscurrent_ex Notification of current preset number.
5. Others [Usage Example] Some other messages No.
6.
