TG NS-C700 Speaker Enceinte OWNER’S MANUAL MODE D’EMPLOI BEDIENUNGSANLEITUNG MANUAL DE INSTRUCCIONES
Thank you for selecting this YAMAHA product. PRECAUTIONS Read this before using the speaker. • To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. • Install the speaker in a cool, dry, clean place - away from windows, heat sources, sources of excessive vibration, dust, moisture and cold. Avoid sources of electrical noise (transformers, motors). To prevent fire or electrical shock, do not expose this unit to rain or water.
SUPPLIED ACCESSORIES CONNECTIONS TO YOUR AMPLIFIER Before making connections, make sure that the amplifier is switched off. Fastener × 4 Loosen PLACING THE SPEAKERS Place the speaker on a TV rack or other stable surface. To prevent the speaker from falling down, attach the fasteners provided in each corner of the speaker's underside.
■How to connect 1 2 Loosen the knob. Remove 10 mm (3/8”) of insulation from each end of the cables, and twist the exposed conductors together neatly and tightly, as shown below. 10 mm (3/8 ”) Good 3 4 ATTACHING THE FRONT COVER The speaker and the front cover are packed separately. To attach the front cover, line up the projections (magnets) on the reverse side of the front cover with their corresponding screw heads on the speaker. No Good Insert the bare wire. Tighten the knob and secure the cables.
SPECIFICATIONS Type .......................... 2-way acoustic suspension speaker system Non-Magnetic shielding type Driver ................................................13 cm (5”) cone woofer × 2 Advanced PMD 3 cm (1”) aluminum dome tweeter DC diaphragm Impedance............................................................................... 6 Ω Frequency Response ............................ 60 Hz to 50 kHz (-10 dB) 100 kHz (-30 dB) Nominal Input Power......................................................
■Подключение 1 2 Ослабьте ручку. Срежьте 10 мм изоляции с обоих концов каждого кабеля и скрутите оголенные провода вместе аккуратно и плотно, как показано ниже. 10 мм Правильно Неправильно 3 4 Вставьте оголенный провод. Затяните ручку и зафиксируйте кабели. Проверьте прочность соединения, попытавшись слегка вытянуть кабели из разъема.