NS-AP9500M/NS-AP9600E HOME CINEMA SPEAKER PACKAGE CONTENTS CONSUMER PRECAUTIONS ............................................................................ 2 UNPACKING .......................................................................................................3 SETTING UP THE SPEAKERS .......................................................................... 4 CONNECTIONS TO THE RECEIVER ................................................................ 7 SPEAKER PLACEMENT .......................
CONSUMER PRECAUTIONS Read these precautions carefully before setting up your NS-AP9500M/9600E speakers. Since these speakers can be wall mounted, it is essential that they are firmly secured. Be sure to consult a reliable source about the best type of hanger for your particular wall’s construction. Secure installation is the purchaser’s responsibility.
UNPACKING After unpacking, check that the following items are contained.
SETTING UP THE SPEAKERS Stand mounting the front speakers You can use the supplied speaker stands SPS-9500T for table top installation. For assembly instructions, please refer to the SPS-9500T owner’s manual which can be found in the SPS-9500T box. Wall mounting the front speakers The front speakers may also be hung on a wall, utilizing the key holes on the rear of the speakers. Use the key hole Wall / wall support * Do not use this screw hole.
Attaching the non-skid pads to the surround speakers Place the satellite speakers on a sturdy, vibration-free surface, such as a well-built stand. Attach the included non-skid pads to the bottom of the surround speakers to prevent the speakers from slipping. Non-skid pads Wall mounting the surround speakers You can also use the screw holes on the back of the speaker for installing the speakers on commercially available speaker brackets.
Positioning the center speaker Place the center speaker on top of the TV, on the floor in front of the TV, or inside the TV rack so that it is stable. When placing the speaker on top of the TV, put the provided fasteners at four points on both the bottom of the speaker and on top of the TV to prevent the speaker from falling.
CONNECTIONS TO THE RECEIVER CONNECTIONS Check to make sure that the receiver has been turned off before making any speaker connections. Connect the (+) terminal of the receiver to the (+) terminal of the speaker. Connect the (–) terminal of the receiver to the (–) terminal of the speaker. Reversing polarity (+/–) will result in unnatural sound reproduction. PROCEDURE For connections, keep the speaker cords as short as possible. Do not bundle or roll up the excess part of the cords.
SPEAKER PLACEMENT This speaker system consists of front, center and surround speakers. — Front speaker placement should be separated by a distance of 6–10ft. If they are placed too close together, there will be a reduction in the stereo effect. Conversely, If placed too for apart, the so called “middleomission” effect will occur and the vocal center fill will be lost. Height of the speaker should be at least at ear level. — Center channel speaker should be placed centered above or below the TV.
SPECIFICATIONS Type Speaker Acoustic suspension Front Quad 4” High Compliance Pulp cone and Rubber Surround + 3/4” soft dome tweeter Center 3” woofer x 2 + 3/4” soft dome tweeter Surround 3” woofer x 1+ 1/2” balanced dome tweeter Frequency Range Front 100 Hz - 40,000 Hz Center 110 Hz - 40,000 Hz Surround 110 Hz - 40,000 Hz Impedance 6 ohms Nominal Input Front 35 W Center 30 W Surround 30 W Maximum Input Front 120 W Center 100 W Surround 100 W Sensitivity (dB/2.83v.
YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CA 90620 http://www.yamaha.