EB RX-E600 ©2004 YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A. CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE ELECTRONICS (UK) LTD.
CAUTION: READ THIS BEFORE OPERATING THIS UNIT 1 2 3 4 5 To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. Install this unit in a well ventilated, cool, dry, clean place away from direct sunlight, heat sources, vibration, dust, moisture or cold. In a cabinet, allow about 10 cm (4 in.) of free space all around RX-E600 for adequate ventilation.
FEATURES English • Minimum RMS output power per channel 40 W + 40 W (6Ω, 20 Hz to 20 kHz, 0.1% THD) • Full operation system remote control • 40-station FM/AM preset tuning • Multi-function RDS reception • SUBWOOFER output terminal The receiver (RX-E600) and DVD player (DVD-E600) are the main units of the YAMAHA Piano Craft Series. You can upgrade the system by adding the cassette deck (KX-E300) and MD recorder (MDX-E300)*. * MD recorder (MDX-E300) may not be available for some areas.
SUPPLIED ACCESSORIES After unpacking, check that the following parts are contained. • AM loop antenna • Remote control POWER 1 2 3 1 4 2 5 3 6 4 7 5 8 6 9 7 0 8 +10 +100 FREQ/RDS MODE–PTY SEEK–START REP RANDOM PROG A B C TIME D E • Indoor FM antenna TAPE DIRECTION PRESET MD TUNER PRESET DVD TAPE AUX MD REC/PAUSE MODE TAPE REC/PAUSE DUBBING SLEEP START DISPLAY • System control cable VOLUME • Batteries (AA, R6, UM-3) 2 0103CRXE400(M).01-02.E 2 2004.06.
GETTING STARTED Remote control operation range English Remote control VOLUME This remote control controls a whole system: not only RX-E600 but also DVD-E600. Moreover, a cassette deck (KX-E300) and MD recorder (MDX-E300) that level up your system can be operated by it.
GETTING STARTED Connecting the speakers and antennas Never plug the AC power cord to the wall outlet until all connections are completed. Follow the steps as shown below to connect the system using the supplied cords and accessories. Be sure all connections are made correctly, that is to say L (left) to L, R (right) to R, “+” to “+” and “–” to “–”. 3 Right speaker Left speaker FM antenna 2 AM loop antenna C IN MD DVD OUT SYSTEM CONNECTOR FM ANT 75Ω UNBAL.
GETTING STARTED English Connecting the system Connecting RX-E600 and DVD-E600 1 2 3 Connect ‰ to ‰ using the Audio pin cable. Insert the plugs into the jacks of the same color. Connect RX-E600 and DVD-E600 with the system control cable. The other SYSTEM CONNECTOR of DVD-E600 is for connecting MDX-E300 or KX-E300. Connect the AC power plug of DVD-E600 to AC OUTLET of RX-E600. This connection allows you to control the power of the system through one-touch operation.
GETTING STARTED Setting the clock You must set the clock before you use the timer functions. The clock is based on a 24-hour system. STANDBY/ON DISPLAY HOUR MIN VOLUME NATURAL SOUND STEREO RECEIVER RX–E600 STANDBY/ON DISPLAY TIMER MEMORY AUTO/MAN'L TIMER ADJ TIMER BASS PRESET/BAND PRESET/TUNING HOUR TREBLE MIN MIN MAX INPUT BALANCE PHONES – + TIME ADJ 1 2 3 4 – + L R PRESET/BAND Turn on the power by pressing STANDBY/ON on the front panel, or POWER on the remote control.
RX-E600 NAMES OF BUTTONS AND CONTROLS 1 2 3 45 6 7 8 English Front panel 9 VOLUME NATURAL SOUND STEREO RECEIVER RX–E600 STANDBY/ON DISPLAY TIMER MEMORY AUTO/MAN'L TIMER ADJ TIMER PRESET/TUNING PRESET/BAND HOUR BASS TREBLE MIN MIN MAX INPUT BALANCE PHONES – 0 q + w – + e 1 STANDBY/ON (@P.9) 2 TIMER indicator (@P.15) 3 DISPLAY (@P.15) 4 TIME ADJ/MEMORY (@P.6/@P.11) 5 AUTO/MAN’L/TIMER (@P.10/@P.15) 6 PRESET/BAND (@P.10) 7 Display (@P.7) 8 PRESET/TUNING / (@P.10) HOUR/MIN (@P.
RX-E600 NAMES OF BUTTONS AND CONTROLS Remote control POWER 1 2 3 6 1 2 3 1 4 2 5 3 6 4 7 5 8 6 9 7 0 8 +10 +100 FREQ/RDS MODE–PTY SEEK–START REP RANDOM PROG A B 4 5 C TIME D E TAPE DIRECTION PRESET 7 9 MD TUNER PRESET DVD TAPE AUX MD REC/PAUSE MODE e TAPE REC/PAUSE DUBBING SLEEP 8 0 q w 1 POWER (@P.9) 2 Preset numbers (@P.11) 3 FREQ/RDS (@P.12) 4 PTY SEEK MODE (@P.13/@P.14) 5 PTY SEEK START (@P.13/@P.14) 6 A/B/C/D/E (@P.11) 7 PRESET / (@P.11) 8 TUNER (RX-E600) (@P.
BASIC OPERATIONS STANDBY/ON TREBLE 1 2 VOLUME STEREO RECEIVER RX–E600 STANDBY/ON TIMER DISPLAY MEMORY AUTO/MAN'L TIMER ADJ TIMER BASS PRESET/TUNING PRESET/BAND HOUR TREBLE MIN MIN MAX INPUT BALANCE PHONES – + – + L R 3 PHONES BASS BALANCE INPUT POWER 1 2 3 1 4 2 5 3 6 4 7 5 8 6 9 7 0 8 +10 +100 5 6 FREQ/RDS MODE–PTY SEEK–START REP RANDOM PROG A B E MD TUNER TAPE AUX MODE If desired, adjust BASS, TREBLE, and BALANCE.
TUNING Listening to the radio You can find radio stations automatically and manually. AUTO/MAN’L PRESET/TUNING / VOLUME NATURAL SOUND STEREO RECEIVER DISPLAY MEMORY AUTO/MAN'L TIMER ADJ TIMER BASS PRESET/BAND PRESET/TUNING HOUR TREBLE MIN MIN MAX INPUT BALANCE PHONES – + – + L 1 2 3 RX–E600 STANDBY/ON TIMER Manual tuning Follow steps 1 and 2 described in “Automatic tuning.” Press AUTO/MAN’L so that “AUTO” disappears from the display.
TUNING The unit can preset station frequencies selected by Automatic tuning or Manual tuning. Up to 40 stations can be stored. With this function, you can select any desired station by pressing the corresponding preset station number. PRESET/TUNING / STEREO RECEIVER Select TUNER as input source by turning INPUT. Press MEMORY for about 2 seconds. • The unit starts presetting stations, “AUTO” and “MEMORY” will flash on the display. Received stations are stored to A1, A2...A8 sequentially.
RECEIVING RDS STATIONS Receiving RDS data RDS (Radio Data System) is a data transmission system by FM stations in many countries. Stations using this system transmit an inaudible stream of data in addition to the normal radio signal. RDS data contains various types of information, such as PS (Program Service), PTY (Program Type), RT (Radio Text), and CT (Clock Time). POWER FREQ/RDS 1 2 3 1 4 2 5 3 6 4 7 5 8 6 9 7 0 8 +10 +100 PS The name of the RDS station being received is displayed.
RECEIVING RDS STATIONS You can locate a desired station by selecting a program type. The unit searches all preset stations into the type of programs currently being broadcast from the RDS stations. 1 2 Tune in the FM station. (Refer to page @10, or you can simply press TUNER on the remote control.) English To locate a station PTY SEEK mode Press PTY SEEK MODE once so that “PTY” and a PTY program flashes on the display.
RECEIVING RDS STATIONS • If you receive an RDS station of some other country, the built-in clock is synchronized with the time setting of the country. • If the built-in clock is not yet set for the current time or reset due to a power failure, etc., it will be set for the time of the CT data automatically, whether this setting is ON or OFF. Optional settings for RDS functions The tuner has the following functions which make use of the RDS data service. These are originally in operation ON.
USING THE BUILT-IN TIMER USING THE BUILT-IN TIMER If you want to use the cassette deck, KX-E300 or the MD Recorder, MDX-E300 for timer play or recording, you must first make the connections as shown in “Connecting the system” on page 5. For details, refer to the instructions supplied with the MDX-E300 or KX-E300. English 3. Timer REC Select the recording component by turning INPUT. If you like to enjoy timer play with TUNER or AUX, select “REC Mode OFF”.
USING THE BUILT-IN TIMER Sleep timer The unit can be turned off automatically at a selected SLEEP time. PRESET MD TUNER PRESET TAPE DVD AUX MD REC/PAUSE MODE SLEEP TAPE REC/PAUSE DUBBING START SLEEP DISPLAY VOLUME 1 2 Play the desired sound source. Press SLEEP repeatedly until the desired sleep time appears in the display.
SYSTEM CONTROL DVD-E600 POWER 1 1 2 3 1 4 2 5 3 6 4 7 5 8 6 9 7 0 8 +10 +100 1 Numeric buttons • +100 button is used when operating MDX-E300.
SYSTEM CONTROL MDX-E300 POWER 1 2 3 4 1 2 3 1 4 2 5 3 6 4 7 5 8 6 9 7 0 8 +10 +100 FREQ/RDS MODE–PTY SEEK–START REP RANDOM PROG A B D E 6,1 8,3 9,4 7,2 TAPE DIRECTION PRESET 0 5 C TIME MD KX-E300 TUNER PRESET DVD TAPE 5 AUX q 1 Numeric buttons 2 REP (Repeat) 3 RANDOM 4 * (Pause) 5 PROG (Program) 6 # (Play) 7 ⁄ › (Skip/Search Forward) 8 $ ! (Skip/Search Backward) 9 & (Stop) 0 MD input q MD REC/PAUSE MD REC/PAUSE MODE TAPE REC/PAUSE DUBBING SLEEP 6 1 # (Play) 2 ⁄ › (
SYSTEM CONTROL When you record by using MDX-E300 or KX-E300, you must first make the connections as shown in “Connecting the system” on page 5. For details, refer to the instructions supplied with the MDX-E300 or KX-E300. A source from the component which is connected to the AUX terminal component can be recorded on a tape or MD. 3 English 2 Before recording Play unit Record unit Dubbing setting There are six different combinations of components.
ADDITIONAL INFORMATION Troubleshooting If the unit fails to operate normally, check the following points to determine whether the fault can be corrected by the simple measures suggested. If it cannot be corrected, or if the fault is not listed in the SYMPTOM column, disconnect the power cord and contact your authorized YAMAHA dealer or service center for help. When taking the service, the MDX-E300 or KX-E300 may be needed. For details, contact your authorized YAMAHA dealer or service center.
ADDITIONAL INFORMATION The remote control does not work. TV functions strangely when the remote control is being used. CAUSE REMEDY The batteries of the remote control are too weak. Replace the batteries with new ones. Remote control is too far away or is being used at an incorrect angle. Use within 6 meters and 60 degree radius. Direct sunlight or lighting (of an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of the unit. Change the position of the unit.
ADDITIONAL INFORMATION Specifications Amplifier section Minimum RMS output power per channel ................................................ 55 W + 55 W (6Ω 1kHz 0.1% THD) .............................. 40 W + 40 W (6Ω 20 Hz to 20 kHz 0.1% THD) DIN Standard output power per channel (Europe model) ................................................ 60 W + 60 W (4Ω 1kHz 0.7% THD) Input sensitivity/Impedance CD/TAPE/MD/AUX ................................................. 150 mV/47 kΩ Frequency response CD etc.
0112CRXE400(M).20-23.E 23 2004.06.
EB RX-E600 ©2004 YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA YAMAHA ELECTRONICS CORPORATION, USA 6660 ORANGETHORPE AVE., BUENA PARK, CALIF. 90620, U.S.A. CANADA MUSIC LTD. 135 MILNER AVE., SCARBOROUGH, ONTARIO M1S 3R1, CANADA ELECTRONIK EUROPA G.m.b.H. SIEMENSSTR. 22-34, 25462 RELLINGEN BEI HAMBURG, F.R. OF GERMANY ELECTRONIQUE FRANCE S.A. RUE AMBROISE CROIZAT BP70 CROISSY-BEAUBOURG 77312 MARNE-LA-VALLEE CEDEX02, FRANCE ELECTRONICS (UK) LTD.