Quick Reference Guide

ManualsBrandsYamaha ManualsAV receiversHTR-3064

- 1 -

PUSH

for Europe

English

Preparing the remote control

Take off the battery compartment cover.

Insert the two supplied AAA batteries into the battery case, following the polarity

markings.

Snap the battery compartment cover back into place.

■

Accessories

■

Items necessary for connection

The following accessories are supplied with this product.

Speakers

External components

Remote control

Front speaker

Ex.

Batteries (2) (AAA, R03,

UM-4)

Center speaker

AM loop antenna

Surround speaker

Indoor FM antenna VIDEO AUX input cover YPAO microphone

Active subwoofer

Ex. Ex.

Cable

• Cables for connecting external components

(may differ depending on the devices you are connecting)

• Speaker cables

(a quantity to match the number of speakers you are connecting)

• Audio pin cable

(for subwoofer)

Playback device such as BD

(Blu-ray Disc)/DVD players

• Use speakers with an impedance of at least 6Ω.

• If you are using a CRT TV, we recommend that you use magnetically shielded speakers.

• Prepare at least two speakers (for front). The priority of the other speakers is as follows:

1 Two surround speakers

2 One center speaker

Summary of content (8 pages)

PAGE 1
English for Europe Quick Reference Guide ■ Accessories The following accessories are supplied with this product. PUSH Remote control Batteries (2) (AAA, R03, UM-4) AM loop antenna Indoor FM antenna VIDEO AUX input cover YPAO microphone Preparing the remote control 1 3 2 1 Take off the battery compartment cover. 2 Insert the two supplied AAA batteries into the battery case, following the polarity markings. 3 Snap the battery compartment cover back into place.
PAGE 2
Connect and install as follows the first time you use this unit. See the following explanations for the connections for each number.
PAGE 3
1 Connect the speakers Surround speaker R L Front speaker R L Caution: • Remove the AC power cord of this unit from the power outlet before connecting the speakers. • Generally speaker cables consist of two parallel insulated cables. One of these cables is a different color, or has a line running along it, to indicate different polarity.
PAGE 4
2 Connect a TV Video input to this unit is output to a TV using output jacks of the same kind. When you have made connections using different types of video such as HDMI and component video, make the same connection with your TV. When viewing, be sure to switch the input source on your TV to match the playback device.
PAGE 5
3 Connect playback device such as BD/DVD players and recorders If your playback device has multiple audio/video outputs, connect with the following priority (A to D) to enjoy a higher quality sounds and images.
PAGE 6
5 Set up the speaker parameters automatically (YPAO) When connection is finished, adjust the status, sizes, and volume balance of the speakers to provide an optimal sound field. This unit is equipped with a YPAO (Yamaha Parametric room Acoustic Optimizer) function that adjusts the speaker balance automatically with a simple procedure. When you use YPAO, a test tone will be output from the speakers for approximately three minutes and acoustic measuring will be performed.
PAGE 7
4 Connect the YPAO microphone to the YPAO MIC jack on the front panel. RECEIVER A YPAO microphone DOCK “MIC ON. YPAO START” appears on the front panel display, and then changes to display the following. YPAO VOL. Press [SETUP] L SL SW C R SR SETUP This completes preparations. To achieve more accurate results, be careful of the following when measuring. • Measuring will take approximately three minutes. Keep the room as quiet as possible during measurement.
PAGE 8
Operation guide A Switches this unit between on and standby modes This unit switches between on and standby mode every time you press this key. TRANSMIT B Choose an input source to listen to RECEIVER The name of the selected input source appears on the front panel display. SLEEP HDMI VOL.