User Manual

ManualsBrandsYamaha ManualsColunasBusiness Som Bar

Table Of Contents

ESB-1090

Front Surround System

Update Guide

Summary of content (8 pages)

PAGE 1
ESB-1090 Front Surround System Update Guide EN
PAGE 2
Table of contents Table of contents 1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.1. Equipment required for firmware update . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1.2. Preparing the firmware. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
1. Introduction 1. Introduction This Guide provides instructions for updating firmware with a USB flash drive on the following products. • ESB-1090 See product pages on the Yamaha website for details regarding the issues resolved, and functions added, by updating firmware. 1.1. Equipment required for firmware update Prepare the following items before attempting to update firmware. • USB flash drive: use a USB flash drive that meets all of the following requirements.
PAGE 4
2. Updating the unit’s firmware 2. Updating the unit’s firmware Update the firmware of the unit. 1. Turn off the unit. 2. Unplug the power cable from the AC wall outlet. 3. Connect the USB flash drive to the UPDATE ONLY jack on the unit. USB flash drive containing the firmware data file 4. Plug the power cable into an AC wall outlet. Note • When the plug is connected to an electrical outlet, the unit may turn on. In that case, press the (power) on the remote control to turn off the power. 5.
PAGE 5
2. Updating the unit’s firmware Notice • Do not unplug the power cable or disconnect the USB flash drive until the following procedures are completed. Note • When the firmware version of the unit is newer than the firmware to be installed, the update does not begin.
PAGE 6
3. Troubleshooting 3. Troubleshooting If the firmware update fails, the indicators will flash as illustrated below. Confirm the problem and try updating the firmware again. 3.1. Flashing (red) indicator 3.1.1. The USB flash drive is not connected to the unit correctly. 1. Terminate the update by pressing the (power) on the remote control. 2. Connect the USB flash drive to the unit correctly. 3. Try updating the firmware again. 3.1.2.
PAGE 7
3. Troubleshooting 3.2.1. The power cable was unplugged while firmware was being updated. In Conference mode: 1. Be sure that the USB flash drive is correctly connected to the unit. 2. Plug the power cord into an AC wall outlet.The firmware update will resume. In Hotel mode or Education mode: 1. Be sure that the USB flash drive is correctly connected to the unit. 2. Plug the power cord into an AC wall outlet. 3. Press the (power) on the remote control.The firmware update will resume.