User Manual

DTX-MULTI 12 Version1.1

The Owner’s Manual bundled with your DTX-MULTI 12 covers version 1.00 of the firmware. This

firmware has now been upgraded to version 1.1, which adds several new functions. The corre-

sponding additions and changes to the bundled Owner’s Manual are described below.

To check your DTX-MULTI 12’s firmware version:

While holding down the [SHIFT] button, turn on the electronic percussion pad.

“Ver : *.**” indicates the current version of the firmware.

 Support for the DT50S/DT50K (Drum Trigger) (pages 101 and 104 of Owner’s Manual)

Pad types have been added for the DT50S/DT50K.

The new trigger parameter “NoiseFilterTable” has been added.

The new trigger parameter “2P Balance” has been added.

The new setting values “14&15” and “16&17” have been added for Copy Trigger parameters “Pad to copy” and “Pad to

replace.”

 Addition of new pad types (page 101 of Owner’s Manual)

New types of pads are now supported as follows.

 Expansion of the Click-track output selection setting range (page 84 of Owner’s Manual)

“ph2” setting has been added for ClkOutSel (Click-track output selection) parameter.

This setting is used to output the click-track via the PHONES jack only, and all other sound via the OUTPUT (L/MONO and

R) jacks only.

 Expansion of the input gain setting range (page 101 of Owner’s Manual)

The input gain setting range is expanded.

NOTE

For details on how to use the drum trigger DT50S/DT50K with the DTX-MULTI 12, see the Drum Trigger Module Setup Manual for DT50S/

DT50K PDF document.

Yamaha Downloads: http://download.yamaha.com

KP125W/125

KP100

KU100

XP120/100Sn

XP120/100Tm

XP80 Snare

XP80 Tom

XP70

TP70S Snare

TP70S Tom

TP70S HiHat

TP70

PCY100

PCY90

Manual Development Group

Published 07/2016 PO*.*-**A0

ZW45140

— 1 —