-EX Owner’s Manual V480360 R0 1 IP 16 200 AP Printed in Japan E
FCC INFORMATION (U.S.A.) 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used. Follow all installation instructions.
■ Precautions • Do not allow water to enter this unit or allow the unit to become wet. Fire or electrical shock may result. • Connect this unit’s power cord only to an AC outlet of the type stated in this Owner’s Manual or as marked on the unit. Failure to do so is a fire and electrical shock hazard. • Do not scratch, bend, twist, pull, or heat the power cord. A damaged power cord is a fire and electrical shock hazard. • Do not place heavy objects, including this unit, on top of the power cord.
Thank you for choosing the DSP unit “DSP1D/DSP1D-EX”, specifically designed for the Yamaha PM1D digital audio mixing system. The DSP1D/DSP1D-EX is an engine controlled by the CS1D control surface. Be sure to ask an authorized Yamaha service engineer to install the boards and set up the unit. Never perform installation and setup by yourself. The following optional boards can be installed in the DSP1D.
A ENGINE ID A/B indicators These indicators indicate whether the DSP1D/ DSP1D-EX is connected to the engine A or engine B channel. Indicator A lights up if the DSP1D/DSP1D-EX is connected to the engine A channel jacks of the CS1D control surface (DIGITAL I/O jack A and CONTROL I/O jack A). Indicator B lights up if the DSP1D/DSP1DEX is connected to the engine B channel jacks of the CS1D control surface (DIGITAL I/O jack B and CONTROL I/O jack B).
K TIME CODE IN connector N OUTPUT 1–6 slot This balanced XLR3-31 connector receives SMPTE time code (LTC) for analog input from the external device. The rated input level is –10 dB, and the pin assignment is as follows. 1=ground, 2=hot, 3=cold Use these slots to connect the INPUT connectors of an analog output unit AO8 series or DIO8 digital I/O unit to output multi-channel digital audio signals from the DSP1D/DSP1D-EX. Use a genuine Yamaha half-pitch 68-pin cable for connection.
Slots (for IDB1D board) Unit Input channel DPS1D INPUT 1-48 & ST IN 1-4* DPS1D-EX INPUT 1-96 & ST IN 1-8 (DSP1D + IDB1D for expansion) *The DSP1D has an empty slot available for the IDB1D board. 460.8 Dimensions 450 ■ 480 ENGINE ID A B CONTROL I/O 1 2 INPUT CONFIGURATION 48CH 96CH 408.7 9.5 399.2 POWER ON/ OFF unit: mm • Specifications and appearance are subject to change without notice for improvement.
YAMAHA CORPORATION Pro Audio Division, #18/3 P.O.
