Operation Manual

ManualsBrandsYamaha ManualsHousehold AppliancesDKC-850

YD274C0

(Disklavier E3 / Disklavier Control Unit DKC-850)

Update Manual

Table of Contents

Updating the Disklavier.............................................................................2

Downloading the Update Program............................................................................ 2

Updating the Disklavier............................................................................................. 4

Summary of content (5 pages)

PAGE 1
(Disklavier E3 / Disklavier Control Unit DKC-850) Update Manual Table of Contents Updating the Disklavier.............................................................................2 Downloading the Update Program............................................................................ 2 Updating the Disklavier.............................................................................................
PAGE 2
Updating the Disklavier Downloading the Update Program You can download the update program in one of two ways. ■ Downloading the Update Program Directly from the Internet 1 Press [INTERNET] on the remote control. The Internet menu screen appears. =Internet= *D-Radio *Update 2 (1/1) *MyAccount Select “Update” with the cursor buttons ([ [ ]), then press [ENTER]. ][ ][ ] (1/1) =Internet= *D-Radio *MyAccount *Update The update screen appears if there is any update available for your instrument.
PAGE 3
Updating the Disklavier 3 Following the instructions on the screen, select the option with the cursor buttons ([ ] [ ] [ ] [ ]), then press [ENTER]. =Update=   -----------------------*Update Fir *Cancel The download process of the update program starts. =Update= Now Downloading... 50% ( 1 / 1 ) 4 After the download process is completed, shut down the Disklavier by pressing [ON/OFF] on the control unit.
PAGE 4
Updating the Disklavier 4 Insert the USB flash memory including the update program into the USB port of the control unit. USB flash memory USB port The update program is ready to be installed. Update the firmware following the procedures in “Updating the Disklavier” on page 4. Updating the Disklavier Update the Disklavier firmware using the update program you downloaded. 1 While holding [PLAY/PAUSE] on the control unit, press [ON/OFF].
PAGE 5
Updating the Disklavier 4 Press [PLAY/PAUSE] to start the update. The update process of the first module takes approximately 3 minutes. Important: DO NOT turn off this unit during update. Important: Be sure to update all the modules. MC v2.20  v3.00 DO NOT REMOVE DISK! When the update of the first module completes, the following confirmation message appears. Confirmation message of the second module  v3.00 v2.10 CTRL-SURE? (PLAY,STOP) Press [PLAY/PAUSE] to start the update of the second module.