English mLAN Interface Card Français Español Owner’s manual Bedienungsanleitung Mode d’emploi Manual de instrucciones Deutsch MY8-mLAN
MY8-(E).book Page 2 Thursday, October 11, 2001 10:05 AM WARNING Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting, damages, fire or other hazards. These precautions include, but are not limited to, the following: • Do not attempt to disassemble or modify the card. Do not apply excessive force to card connectors or other card components.
MY8-(E).book Page 3 Thursday, October 11, 2001 10:05 AM Thank you for purchasing the Yamaha MY8-mLAN. The MY8-mLAN is an interface card that provides mLAN interfacing. mLAN is a digital network designed for music and based on the IEEE 1394 high performance serial bus. mLAN makes it easy to construct sophisticated networks for audio and MIDI signals that can be re-configured without changing the physical cabling (as was necessary with previous systems).
MY8-(E).book Page 4 Thursday, October 11, 2001 10:05 AM Table of Contents Introduction ................................................................................... 3 English Package Contents........................................................................... 3 How to install the MY8-mLAN ....................................................... 5 Names and Functions..................................................................... 6 DIP switch (SW1) settings................................
MY8-(E).book Page 5 Thursday, October 11, 2001 10:05 AM How to install the MY8-mLAN 1. Set the MY8-mLAN’s DIP switch (SW1) according to your application. For details refer to page NOTE It is not possible to change the setting of the DIP switch (SW1) after the MY8-mLAN is installed. You must set the DIP switch before installation. If you want to change the settings, you must turn off the host device, remove the MY8-mLAN, and then change the settings. 2. Install the MY8-mLAN into your device.
MY8-(E).book Page 6 Thursday, October 11, 2001 10:05 AM Names and Functions English 1 2 3 A mLAN (IEEE1394) jacks These jacks are used to connect mLAN devices or IEEE1394-compatible devices via IEEE1394 standard (6-pin) cables. Each jack has an LED in the upper left corner to indicate the following statuses. green : The MY8-mLAN or connected device is a “leaf” node. off : Not connected. red : When there is a possibility that the sound will be interrupted.
MY8-(E).book Page 7 Thursday, October 11, 2001 10:05 AM DIP switch (SW1) settings English The MY8-mLAN has a switch that specifies whether audio input/output and MIDI input/output via mLAN will be enabled. In this switch, moving the white slider toward the number will turn the setting “OFF,” and moving it toward the side marked ON will turn the setting “ON.” The following settings are assigned to each number 1–8.
English MY8-(E).
MY8-(E).book Page 9 Thursday, October 11, 2001 10:05 AM DIP switch settings for typical applications This device performs A/D conversion of analog audio input, and sends it to other devices on the mLAN bus. Thus for the MY8-mLAN installed in this device, only the audio output plugs are valid, and the audio input plugs and MIDI input/output plugs are invalid. Set the DIP switches as follows. 1-ON, 2-OFF, 3-OFF, 4–8 may be set as desired. (However, be sure not to turn all of them OFF.
MY8-(E).book Page 10 Thursday, October 11, 2001 10:05 AM Connections Here’s how to make connections from the MY8-mLAN to other mLAN devices or to your computer. English Connecting an mLAN (IEEE1394) device Use an IEEE 1394 standard cable (6 pin) to connect the mLAN (IEEE 1394) jack of the MY8-mLAN to the mLAN (IEEE 1394) connector of the other mLAN (IEEE 1394) device.
MY8-(E).book Page 11 Thursday, October 11, 2001 10:05 AM About mLAN connections • Use the “mLAN Patchbay” application program to make settings from a Macintosh computer that is equipped with a FireWire port. • Use the “mLAN Patchbay” application program to make settings from a Windows computer that is equipped with a COM port or other serial port. (However, you will need another mLAN device that has a serial port.
MY8-(E).book Page 12 Thursday, October 11, 2001 10:05 AM Internal Configuration of the MY8-mLAN English The signal flow within the MY8-mLAN is shown by the following diagram. mLAN device mLAN jacks1, 2 mLAN MIDI IN mLAN MIDI OUT mLAN MIDI/ MIDI conversion MIDI/ mLAN MIDI conversion mLAN audio input mLAN audio output mLAN audio/Audio direct conversion Audio/mLAN audio direct conversion MY8-mLAN OPTION I/O slot AW4426, 01V, etc.
MY8-(E).book Page 13 Thursday, October 11, 2001 10:05 AM LED Messages LED messages mLAN1, 2 Indicates the status of the mLAN (IEEE 1394) jack. RT/ERR Indicates “root” node and error. ACTIVE Indicates the status of the relay function between mLAN (IEEE 1394) jacks. Status Red ..... Disconnecting the connection will interrupt the sound on the bus (system). Green... The connection is a “leaf” node. Red/Orange ... An error has occurred. Green ... The MY8-mLAN is a “root” English Function node.
MY8-(E).book Page 14 Thursday, October 11, 2001 10:05 AM English Specifications mLAN IEEE1394 High Performance Serial Bus Data Rate S200, Isochronous Resource Manager capable, Bus Manager capable, Connection Manager Conforms to IEC61883-6 Audio and Music Protocol Digital Audio 8in/8out, MIDI 1in/1out Sampling rate 44.1 kHz, 48 kHz Jacks Front: mLAN IEEE1394 (1/2), Rear: OPTION I/O slot connector Display mLAN 1/2 LED, ACTIVE LED, RT (Root)/ERR (Error) LED Power consumption 2.
MY8-(E).
MY8-(E).
MY8-Hyo4.fm Page 13 Thursday, September 20, 2001 9:26 AM YAMAHA CORPORATION This document is printed on recycled chlorine free (ECF) paper with soy ink. Auf Recycling-Umweltpapier gedruckt. Ce document a été imprimé sur du papier recyclé non blanchi au chlore. Este documento se ha impreso reciclado en papel sin cloro alguno. Pro Audio & Digital Musical Instrument Division P.O. Box 3, Hamamatsu, 430-8651, Japan © 2001 Yamaha Corporation V000000 010APAP2.
