OWNER'S MANUAL MODE D'EMPLOI
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOI OPEN / / / /,\ \ .\ \ CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
IMPORTANT SAFETY INSTRUCTIONS FCC INFORMATION (for US customers) IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product. 2 IMPORTANT: When connecting this product to accessories and/or another product use only high quality shielded cables. Cable/s supplied with this product MUST be used.
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. 1 To assure the tinest performance, please read this manual carefully. Keep it in a safe place for future reference. 2 Install this sound system in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. Allow ventilation space of at least 30 cm (11-13/16 in) on the top, 20 cm (7-7/8 in) on the left and right, and 20 cm (7 -7/8 in) on the back of this unit.
CONTENTS OPERATION INTRODUCTION FEATURES SUPPLIED ACCESSORIES CONTROLS AND FUNCTIONS Front panel Remote contro!..
CONTROLS AND FUNCTIONS (3', @VAMAHA .~.- -, ::(}- " -' (~) ill POWER Press inward to the ON position to tum on the power of this unit. You can set this unit to standby mode by pressing (') button on the remote control or tum on the unit by pressing I button on the remote control when this unit is turned on, Press again to release it outward to the OFF position to turn off this unit. .r,T¥:, .;~,*m-<.
CONTROLS AND FUNCTIONS @ PURE DIRECT and indicator Reproduces any input source in the purest sound possible. The indicator above it lights up when this function is turned on. See page 10 for details. ® VOLUME Control the sound output level. This does not affect the REC level for recording. G) Input selector buttons cr'·>-- - - - - . , Select the input source you want to listen to. ® Amplifier control buttons INPUT Select the input source you want to listen to.
CONTROLS AND FUNCTIONS The remote control transmits a directional infrared beam. Be sure to aim the remote control directly at the remote control sensor on the front panel of this unit during operation. °1:; ~ .~~ Kin 00::6-0 o iJ -.- ~:~ 1 •I• 30" Press the "iffY part and slide the battery compartment cover off. I Wlthln6m 30' (20 ft) ------.
CONTROLS AND FUNCTIONS ' '-4) .m";:, ~::·:;·:;" ~~ DC F\ ..--.., ~ ..--- o \j (8) (Asia and General models) CD CD input jacks Connect a CD player. See page 6 for connection infonnation. ® PHONO jacks and GND terminal The PHONO jacks are designed to connect a turntable with an MM cartridge. See page 6 for connection infonnation. @ Audio input/output jacks Connect external components, such as a tuner, etc. See page 6 for connection infonnation.
CONNECTIONS CAUTION • Do not connect this unit or other components to the main power until all connections between components are complete. • All connections must be correct: L (left) to L, R (right) to R, "+" to "+" and "-" to "_". If the connections are faulty, no sound will be heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lack bass. Also, refer to the owner's manual for each of your components.
CONNECTIONS CAUTION • The IMPEDANCE SELECTOR must be set to the appropriate position before connecting one or two speaker sets. See page 5 for details. • Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit and/or the speakers. • Do not connect this unit or other components to the main power until all connections between components are complete.
CONNECTIONS To the wall outlet with the supplied power cable (Asia and General models) • VOLTAGE SELECTOR (Asia and General models only) The VOLTAGE SELECTOR on the rear panel ofthis unit must be set for your local main voltage BEFORE plugging the supplied power cable into the wall outlet. Improper setting of the VOLTAGE SELECTOR may cause damage to this unit and create a potential fire hazard.
PLAYING AND RECORDING 3 3 2,7 Rotate the INPUT selector on the front panel (or press one of the input selector buttons on the remote control) to select the input source you want to listen to. The indicator of the selected input source lights up. or 4 Front panel 1,6 Remote control 3 6 4 1 Rotate the SPEAKERS selector on the front panel to select SPEAKERS A, B or A+B. Rotate VOLUME on the front panel to the extreme counterclockwise position. VOLUME.
PLA YING AND RECORDING • 6 Rotate VOLUME on the front panel (or press VOL +/- on the remote control) to adjust the sound output level. VOLUME Using the PURE DIRECT switch Routes input signals from your audio sources. As a result, the input signals bypass the BASS, TREBLE, BALANCE and LOUDNESS controls, thus eliminating any alterations to the audio signals to produce more direct and high-grade sound from all input sources. PUFl£\l:}'RECT ::: o-E-- or Front panel o 1\ Remote control .
PLA YING AND RECORDING • Adjusting the LOUDNESS control Retain a full tonal range at any volume level, thus compensating for the human ears' loss of sensitivity to high and low-frequency ranges at low volume. CAUTION If the CD DIRECT AMP switch (or the PURE DIRECT switch) is turned on with the LOUDNESS control set at a certain level, the input signals bypass the loudness control, resulting in a sudden increase in the sound output level.
TROUBLESHOOTING Refer to the chart below if this unit does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, set this unit to the standby mode, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center. • General Problems Possible Causes Pressing the POWER switch on the front panel does not turn on this unit. The POWER on indicator also does not light up.
TROUBLESHOOTING Problems No sound Possible Causes Solutions Refer to page Sound is muted. Press MUTE on the remote control to resume the audio output. 3 Incorrect cable connections. Connect the stereo cable for audio units and the speaker wires properly. If the problem persists, the cables may be defective. 6 No appropriate input source has been selected. Select an appropriate input source with the INPUT selector on the front panel (or one of the input selector buttons on the remote control).
TROUBLESHOOTING • Remote control Problems The remote control does not work nor function properly. 14 En Solutions Refer to page The remote control is too far away or tilted too much. The remote control will function within a maximum range of 6 m (20 ft) and no more than 30 degrees offaxis from the front panel. 4 Direct sunlight or lighting (from an inverter type of fluorescent lamp, etc.) is striking the remote control sensor of this unit. Reposition this unit or lightning.
SPECIFICATIONS CONTROL SECTION POWER SECTION • Minimum RMS output power (8 D, 20 Hz to 20 kHz, 0.019% THD) (6 D, 20 Hz to 20 kHz, 0.03% THD) • Dynamic Power (IHF) (8/6/4/2 D) . . ........ 90 W+90W .......... 105 W+ 105 W ...... 135/160/200/240 W . • Maximum Output Power [Europe model only] (I kHz, 0.7% THD, 4 D).. [Asia and General models only] (JEITA) (I kHz, 10% THD, 8/6 D) .. 160 W ... 140/160 W • IEC Output Power [Europe model only] (I kHz, 0.019% THD, 8 D) . • Power Band Width (0.
Limited Guarantee for European Economic Area (EEA) and Switzerland Thank you for having chosen a Yamaha product. In the unlikely event that your Yamaha product needs guarantee service, please contact the dealer from whom it was purchased. If you experience any difficulty. please contact Yamaha representative oftice in your country. You can find full details on our website (http://www.yamaha-hifi.coml or http://www.yamaha-uk,comlfor U.K. resident).
Garantie Limitee pour l'Espace Economique Europeenne et la Suisse Merci d'avoir porte votre choix sur un produit Yamaha. Dans I'hypothese ou vous devriez recourir au service de notre garantie apres-vente, veuillez contacter votre revendeur Yamaha. Si vous rencontrez la moindre difficulte. n'hesitez pas 11 contacter directement Yamaha dans votre pays de residence. Vous pouvez trouver toutes informations complementaires sur notre site Web (http://www.yamaha-hifi.coml ou http://www.yamaha.uk.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~.~~.~~.~0".~0".~~.~0".~~_~~_'
~~~~~~~~~~~~~~~~~~~~~~MMMMMM~~~MMMMMMM~~~~~~~~~M~ ~ ~ ~ ~ ~;i t~: ~ t{: ~ ~.~ ~ t~: t~: t~: t~: ~: t~~ t~: t~: t1 $ ~.~ ~ ",.~ ~ ~;: ~ ~ ~;~ ~1 ~~: ~ t~: t~: ~{: t~: a ~ t{: t~: t~: t{: t{: ~ M t~: t~: t~~ ~: ~: ~ ~.~ ~ ",.~ ~:'<: t~: ~~ ~: ~: ~ M ~ ~;~ ~:~ ~~ t~~ ~: }: ~ t~: t~: ~ M Y-;"9. l~i\KtANJrliE lDJES ~ §vr.lE~:RE/C i\JJ>JPA[{JE:JrLS JPll[(()1\T}[QtlJf1:§ YAJYJLAJIA ~ Yamaha Canada Musique Llee.
YAMAHA Home Audio products are designed and manufactured to provide a high level of trouble-free performance. YAMAHA Electronics Corporation, USA, is proud of the experienced craftsmanship that goes into each and every YAMAHA Home Audio product. YAMAHA sells its Home Audio products only through a network of high quality, specially authorized dealers and is pleased to offer the following Limited Warranty, which applies only to products purchased from our authorized dealers.
