UAB Front Surround System Contents Supplied items ...................................................................... 2 Features ................................................................................. 3 Frequently asked questions................................................. 3 Part names and functions (sound bar) ................................ 4 Installation............................................................................. 5 Connections.........................................
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USERSERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
CAUTION: READ THIS BEFORE OPERATING YOUR UNIT. • To assure the finest performance, please read this manual carefully. Keep it in a safe place for future reference. • Install this unit in a well ventilated, cool, dry, clean place - away from direct sunlight, heat sources, vibration, dust, moisture, and/or cold. For proper ventilation, allow the following minimum clearances.
Supplied items Make sure you have received all of the following items. Sound bar Remote control Battery x 2 (AAA, R03, UM4) Optical cable (1.5 m [4.
Features Frequently asked questions Enjoy powerful and realistic sound from the sound bar with built-in subwoofer, and easy installation and connection to a TV and other devices. The following section covers popular functions and frequently asked questions about the sound bar. Q1 Can I operate the sound bar using the remote control of the TV? Switching between the remote controls of the TV and sound bar is inconvenient. A1 Yes.
Part names and functions (sound bar) Sound bar (front panel) Sound bar (rear panel) A Indicators H TV input jack Indicate the status of the sound bar. The indicators will dim automatically if no operations are performed for 5 seconds. Refer to “Operations” (p.8 to 9) for the main functions of the indicators. B Remote control sensor Receives infrared signals from the remote control of the sound bar (p.8).
Installation Place the sound bar on a flat surface such as on top of a TV cabinet. Removing the stands How to install on the wall When the sound bar blocks the view of the lower part of the TV screen or the remote control sensor of the TV, remove the stands (18 mm [3/4"]) of the sound bar to adjust its height. 1 Attach the mounting template on a wall and mark for the screw holes. HINT Tapes or thumbtacks • Use the TV Remote Repeater function (p.
Connections Connect to a TV (or other peripheral device). Sound bar (rear) CAUTIONS • Do not connect the power cable of the sound bar to the AC wall outlet before making connections. • Do not use excessive force when inserting the cable plug. Doing so may damage the cable plug or AC wall outlet. Power cable 1 Connect the TV and sound bar with the optical cable (supplied). Remove the cap of the optical cable and check the direction of the plug.
Analog connection of an external device (game console) You can connect an external device, such as a game console or TV that does not have an optical output, to the ANALOG input jacks of the sound bar. Digital connection of an external device You can connect an external device that has a coaxial digital audio output, such as a DVD player, to the COAXIAL input jack of the sound bar.
Operations 1 Input keys Preparing the remote control Remote control signal transmitter Transmits infrared signals. Select an input source to be played back. TV ....................TV audio BD/DVD ...........Audio from a device connected to the BD/DVD input jack COAXIAL.........Audio from a device connected to the COAXIAL input jack ANALOG .........Audio from a device connected to the ANALOG input jack BLUETOOTH (YAS-103 only) .........................
Decoder indication 4 (power) key Turns on or off (standby) the sound bar. 7 CLEAR VOICE key Enables/disables the clear voice function. When this function is enabled, you can enjoy clear voice sounds while watching movies, TV dramas, news programs or sports programs. Green (turned on) Red (Bluetooth standby) The sound bar supports the following audio signals. You can check the type of the input audio signal by the color of the indicator.
Listening to the sound from a Bluetooth device (YAS-103 only) Pairing a Bluetooth device with the sound bar When connecting to a Bluetooth device for the first time, “pairing” between the device and sound bar is required. “Pairing” is necessary for each Bluetooth device you use. Once “pairing” is completed, subsequent connection will be made automatically. 1 You can listen to the wireless sound from a Bluetooth device, such as a smartphone or digital music player.
Playing back audio from a Bluetooth device on the sound bar 1 With the sound bar turned on, press the BLUETOOTH key on the sound bar’s remote control to select Bluetooth as the input source. The BLUETOOTH indicator on the front panel lights up in green. Lights up 2 The Bluetooth standby mode allows you to turn on (or off) the sound bar automatically, that interlocked by the operation of the Bluetooth device.
Settings 4-2 While pointing your TV’s remote control at the remote control sensor, hold down the mute key for more than 1 second twice or three times. Programming the sound bar with the TV’s remote control (TV’s remote control learning function) Approx. 30 cm (1 ft) Once you program the sound bar, you can control it with your TV’s remote control for functions such as turning on/off the TV and sound bar simultaneously, or volume up/ down and muting/unmuting of the sound bar.
6 6-1 Teach the sound bar the “Volume (+)” code of the TV’s remote control. Clearing all programmed functions Press VOLUME (+) on the front panel of the sound bar. 1 6-2 While pointing your TV’s remote control at the remote control sensor, hold down the volume (+) key for more than 1 second twice or three times. Result Successfully learned Bleep/buzzer 7-1 When the sound bar is in the learning mode, the indicators on the front panel flash as shown below.
Sending the TV’s remote signal through the sound bar (TV Remote Repeater function) When the TV Remote Repeater function is enabled, the sound bar relays the TV’s remote signal received by the front sensor to the rear transmitter. This function should be enabled when you place the sound bar in front of your TV and you cannot operate your TV with the TV’s remote control. NOTE • This function is available only when your TV’s remote control uses infrared signals.
Troubleshooting Audio Refer to the table below when the sound bar does not function properly. If the problem you are experiencing is not listed below or if the instructions below do not help, turn off the sound bar, disconnect the power cable, and contact the nearest authorized Yamaha dealer or service center. First, check the following: A The power cables of the sound bar, TV and playback devices (such as BD players) are connected to AC wall outlets securely.
Remote control Problem Cause Remedy The sound bar cannot be controlled using the remote control. The sound bar is out of the operating range. Use the remote control within the operating range (p.8). The batteries are weak. Replace with new batteries (p.8). The remote control sensor of the sound bar is exposed to direct sunlight or strong lighting. Adjust the lighting angle, or reposition the sound bar. The TV cannot be controlled using the TV’s remote control.
Bluetooth (YAS-103 only) Problem Cause Remedy Cannot make the sound bar paired with the Bluetooth device. BLUETOOTH is not selected as the input source. Select BLUETOOTH as the input source. The device does not support A2DP. Perform pairing operations with a device which supports A2DP. A Bluetooth adaptor, etc. that you want to pair with the sound bar has a password other than “0000”. Use a Bluetooth adaptor, etc. whose password is “0000”. The sound bar and device are too far apart.
Specifications Item Amplifier Section Front Speaker Section Subwoofer Section Decoder Input Jacks Bluetooth (YAS-103 only) specifications Maximum Rated Output Power Front L/R 30 W x 2 ch Subwoofer 60 W Type Acoustic suspension type (Non-magnetic shielding type) Driver 6.5 cm (2-1/2") cone x 2 Frequency Response 150 Hz to 22 kHz Type Bass reflex type (Non-magnetic shielding type) Driver 7.
The following description applies to YAS-103 only. Bluetooth • Bluetooth is a technology for wireless communication between devices within an area of about 10 meters (33 ft) employing the 2.4 GHz frequency band, a band which can be used without a license. Handling Bluetooth communications • The 2.4 GHz band used by Bluetooth compatible devices is a radio band shared by many types of equipment.
AVEEA11102A Important Notice: Guarantee Information for customers in EEA* and Switzerland English For detailed guarantee information about this Yamaha product, and Pan-EEA* and Switzerland warranty service, please either visit the website address below (Printable file is available at our website) or contact the Yamaha representative office for your country. * EEA: European Economic Area http://europe.yamaha.
-A DRILL HERE I PERCER CIC DRILL HERE I PERCER CIC FRAME SIZE : 890 mm x 88 mm ( 35" x 3 1/2" ) DIMENSIONS DU CADRE : 890 mm x 88 mm (35 po x 3.
OYAMAHA Thank you for purchasing a new product from Yamaha Electronics. We'd like to continue providing you with high quality products and better service. So, we've made it simple to register your new product purchase online. Please take a few minutes to visit our website at www.yamaha.com/YEC/registration/ and complete the . information and questions included there. We appreciate your business and we look forward to hearing from you.
8YAMAHA For details of products, please contact your nearest Yamaha representative or the authorized distributor listed below. Pour plus de details sur les produits, contactez votre representant Yamaha le plus proche de chez vous ou le distributeur agree indique ci-dessous. NORTH AMERICA CANADA Yamaha Canada Music Ltd. 135 Milner Avenue, Tronto ON M 1S 3R 1, Canada U.S.A. Yamaha Corporation of America 6600 Orangethorpe Ave., Buena Park, Calif. 90620, U.S.A.
ASIA MIDDLE EAST TURKEY/CYPRUS Yamaha Music Europe GmbH Siemensstrasse 22-34, 25462 Rellingen, Germany THE PEOPLE'S REPUBLIC OF CHINA Yamaha Music & Electronics (China) Co.,Ltd. 2F, Yunhedasha, 1818 Xinzha-lu , Jingan-qu, Shanghai, China OTHER COUNTRIES Yamaha Music Gulf FZE LOB 16-513, P.O.Box 17328, Jubel Ali , Dubai , United Arab Emirates INDIA Yamaha Music India Pvt. Ltd. Spazedge building, Ground Floor, Tower A, Sector 47, GLirgaon- Sohna Road, Gurgaon, Haryana, India INDONESIA PT.
OYAMAHA LIMITED WARRANTY ON HOME AUDIO PRODUCTS Thank you for selecting a YAMAHA product. YAMAHA products are designed and manufactured to provide a high level of defect-free performance. Yamaha Corporation of America ("YAMAHA") is proud of the experience and craftsmanship that goes into each and every YAMAHA product.
