Supplementary Manual

ManualsBrandsYamaha ManualsDigital MixersYamaha 02R96 Version 2 V2.1

02R96 V2.1 Supplementary Manual

02R96 system software V2.1 contains the following changes from V2.0.

❏

MIX C-R SOURCES parameter added to

Control Room Monitor (page 137)

A “MIX C-R SOURCES” parameter has been added in the

CONTROL ROOM SETUP page. In V2.0, you could

choose one item from 2TR D1, D2, D3, A1, or A2 as a

monitor source, plus other sources (STEREO, ASSIGN1,

or ASSIGN2). In V2.1, you can turn the MIX C-R

SOURCES parameter off to disable this simultaneous

selection.

❏

MIX MONITOR SOURCES parameter

added to Surround Monitor (page 138)

A “MIX MONITOR SOURCES” parameter has been

added to the SURROUND MONITOR page. In V2.0, you

could simultaneously choose a BUS and SLOT as the

monitor source, but in V2.1 you can turn this parameter

off to disable this simultaneous selection.

❏

THX presets added to Surround Monitor (page 139-141)

Presets for the THX pm3 monitor system have been added to the bass management settings for surround monitor-

ing. Several supplements have also been added regarding the surround monitor settings, so please replace the cor-

responding pages with the following.

Conﬁguring Surround Monitoring

Surround monitoring, including speaker setup, monitor matrix, Bass Management, and mon-

itor alignment, is conﬁgured on the Surround Monitor Setup page.

1 Use the MONITOR [DISPLAY] button to locate the Surround Monitor Setup

page.

Summary of content (4 pages)

PAGE 1
02R96 V2.1 Supplementary Manual 02R96 system software V2.1 contains the following changes from V2.0. ❏ MIX C-R SOURCES parameter added to Control Room Monitor (page 137) A “MIX C-R SOURCES” parameter has been added in the CONTROL ROOM SETUP page. In V2.0, you could choose one item from 2TR D1, D2, D3, A1, or A2 as a monitor source, plus other sources (STEREO, ASSIGN1, or ASSIGN2). In V2.1, you can turn the MIX C-R SOURCES parameter off to disable this simultaneous selection.
PAGE 2
Use the cursor buttons to select the parameters, and use the Parameter wheel, INC/DEC buttons, and [ENTER] button to set them. SPEAKER SETUP: These parameters are for setting the volume balance of the surround monitor speakers. Select the OSC (Oscillator) parameter and choose from PINK NOISE, 500-2K (pink noise through a 500 Hz to 2 kHz BPF), 1K (1 kHz sinewave), or 50 Hz (50 Hz sinewave). Use the ON/OFF button to turn the Oscillator on and off.
PAGE 3
• BASS MANAGEMENT You can set the filter and attenuator settings for each Surround Monitor Channel using eight preset Bass Management modes. The following presets are available: No.
PAGE 4
(4) Movie LFE120Hz This preset is the same as preset (2) mentioned above, except that the output level of surround channels is set to –3 dB when the Monitor Matrix mode is 5.1 or 6.1. This preset is suitable for movie production. (5) Bypass Use this preset not only for bass management but to bypass all parameters, such as the LFE level & LPF, surround channel level, etc. To disable only the bass management, select another preset, then turn off the BASS MANAGEMENT ON/OFF button.