EN DE FR ES IT IPA8200 Owner’s Manual 1 RU Italiano Español Français Deutsch English
Explanation of Graphical Symbols The lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.
PRECAUTIONS PLEASE READ CAREFULLY BEFORE PROCEEDING * Please keep this manual in a safe place for future reference. WARNING Always follow the basic precautions listed below to avoid the possibility of serious injury or even death from electrical shock, short-circuiting, damages, fire or other hazards. These precautions include, but are not limited to, the following: Power supply/Power cord Water warning • Only use the voltage specified as correct for the device.
condensation might have occurred, leave the device for several hours without turning on the power until the condensation has completely dried out. Connections • Before connecting the device to other devices, turn off the power for all devices. Before turning the power on or off for all devices, set all volume levels to minimum. • Turn off the power before connecting speakers, and use only the speaker cables for connecting speakers to the speaker jacks.
Introduction Thank you for purchasing the Yamaha IPA8200 power amplifier. In order to take full advantage of the IPA8200’s functionality and to ensure trouble-free operation, please read this owner’s manual carefully before use. After you have read the manual, keep it in a safe place for reference when needed.
Contents Introduction............................................................................................................. 5 Features .............................................................................................................. 5 Precautions when rack-mounting the unit ........................................................... 5 Controls and Functions ......................................................................................... 7 Front Panel ............................
Controls and Functions Front Panel Security cover q POWER switch and indicator Turns power to the unit on or off. The indicator lights green when the power is on. w PROTECT indicator When the protection system is active, the indicator lights red. When this is lit, the amplifier or power supply is automatically shut down, and no sound will be output from the speakers. e CLIP indicator This indicator will light red when the output power exceeds 100 W for an 8Ω load or 200 W for a 4Ω load.
Controls and Functions Rear Panel q e q INPUT connectors These are balanced input connectors. The included Euroblock connectors can be used to make connections here. w SPEAKERS connectors These are barrier strip type speaker output connectors. NOTE • If using BRIDGE mode, connect the speakers to the “+” pin of channels A/C/E/G and the “–” pin of channels B/ D/F/H. • Do not connect the pin marked NC located in the center of the bottom row of the barrier strip connectors.
Mode settings Speakers can be connected to the IPA8200 using the following three mode settings. The total load impedance of the speakers that can be connected will depend on the mode setting. Do not use a setup that has a lower impedance than the minimum values shown below. STEREO mode BRIDGE mode If the rear panel MODE switch is set to STEREO, each channel will operate independently. You can use the front panel attenuators to adjust the attenuation for each channel independently.
Connections Input jack connections (Euroblock) Please be sure to use the supplied Euroblock connectors. If you lose them, contact your nearest Yamaha dealer. ● Cable preparation • To prepare the cable for attachment to a Euroblock connector, strip the wire as shown in the illustration, and use stranded wire to make connections. With a Euroblock connection, the stranded wire may be prone to breakage because of metal fatigue due to the weight of the cable or due to vibration.
Troubleshooting Indicator(s) Possible cause Remedy Protection circuit CLIP indicator is lit. Output exceeds 100 W (8Ω) or 200 W (4Ω). Lower the input level. Limiter circuit will operate to protect the power amp and power supply. PROTECT indicator is lit. Speaker output connector is shorted. Check whether the speaker output connector or speaker cable could be shorted, and then power-cycle the IPA8200. If the PROTECT indicator is still lit, contact your Yamaha dealer.
Specifications General Specifications Output Power 1kHz, THD+N=1% 20Hz-20kHz, THD+N=1% 1kHz, 20ms Burst 4Ω per channel 200W x 8 8Ω per channel 100W x 8 8Ω / BRIDGE 400W x 4 4Ω per channel 180W x 8 8Ω per channel 90W x 8 8Ω / BRIDGE 360W x 4 4Ω per channel 200W x 8 8Ω per channel 100W x 8 8Ω / BRIDGE 400W x 4 Maximum Input Level +24dBu Input Impedance Input Sensitivity (dBu) 8Ω, Att. max Voltage Gain Att.
Specifications CH A, C, E, G Block Diagram + – G HPF Fc=20Hz + – Comp. GAIN ATTENUATOR MUTE HA HPF Fc=20Hz G HPF Fc=55Hz BA STEREO MODE BRIDGE PARALLEL HPF Fc=55Hz STEREO BRIDGE PARALLEL CH B, D, F, H HPF ATTENUATOR MUTE HA STEREO MODE BRIDGE PARALLEL Clip Level Detect P.Amp Signal Level Detect Output Filter SPEAKERS – + A, C, E, G – + B, D, F, H Comp. BA Level Detect Inv P.Amp Signal Level Detect HPF GAIN 406.5 (16") 377.
Specifications Current Draw Idle 1/8 power 1/3 power 8Ω/ch 4Ω/ch 8Ω/ch 4Ω/ch Line Current (A) 100/120V 230/240V 0.8 0.4 1.9 1.0 3.3 1.5 3.9 1.8 7.7 3.3 In 69 189 327 389 774 Power (W) Out 0 100 200 267 533 Dissipated 69 89 127 122 241 Thermal Dissipation Btu/h kcal/h 235 59 304 77 433 109 417 105 821 207 1/8 power is typical of program material with occasional clipping. Refer to these figures for most applications. 1/3 power represents program material with extremely heavy clipping.
MEMO 60 IPA8200 Owner’s Manual
EN Information for Users on Collection and Disposal of Old Equipment This symbol on the products, packaging, and/or accompanying documents means that used electrical and electronic products should not be mixed with general household waste. For proper treatment, recovery and recycling of old products, please take them to applicable collection points, in accordance with your national legislation and the Directives 2002/96/EC.
ES Información para Usuarios sobre Recolección y Disposición de Equipamiento Viejo Este símbolo en los productos, embalaje, y/o documentación que se acompañe significa que los productos electrónicos y eléctricos usados no deben ser mezclados con desechos hogareños corrientes. Para el tratamiento, recuperación y reciclado apropiado de los productos viejos, por favor llévelos a puntos de recolección aplicables, de acuerdo a su legislación nacional y las directivas 2002/96/EC.
For details of products, please contact your nearest Yamaha representative or the authorized distributor listed below. Para detalles sobre productos, contacte su tienda Yamaha más cercana o el distribuidor autorizado que se lista debajo. Die Einzelheiten zu Produkten sind bei Ihrer unten aufgeführten Niederlassung und bei Yamaha Vertragshändlern in den jeweiligen Bestimmungsländern erhältlich.
Yamaha Pro Audio global web site: http://www.yamahaproaudio.com/ Yamaha Manual Library http://www.yamaha.co.jp/manual/ U.R.G.
