Thank you for purchasing the YAMAHA R0 AM/FM stereo receiver. CONTENTS HE OPERATING YOUR R-10 BLOCK DIAGRAM OWNER'S MANUAL "l k IMPORTANT Please record the serial number of our uni i1 ing space brow Mabel R0 Serial No.: The serial number is located on the rear of the cabinet, Bataan his Owner's Manual in & sate place for sulfurs reference.
CAUTION : — READ THIS BEFORE OPERATING YOUR R-10 1 The R-10 s & sophisticated stereo receiver. To ensure proper ingratiating for the jest possible performance, please read this manual carefully. 2 Chase the installation of your B-10 carefully. Avoid placing it in direct sunlight or close to a source of heat, Alas avoid locations subject to vibration and excessive dust, heat, dole or moisture.
Q—l D CONNECTIONS = CONNECTING THE SPEAKERS The matching impedance of this amplifier is B ohms. Either one or two pairs of speakers may be connected. 1f only one pair is cannoned the recommended speaker impedance may be anywhere between 4 and 16 ohms. If two pairs are connected, however, it is advisable 10 use speakers with at teats an 8 ohm impedance for optimum performance.
1# necessary, an outdoor antenna may be used for improved AM reception. Connect 2 5—10 meter length of insulated wire to the AM Ant terminal and run it outdoors. » CONNECTING THE FM ANTENNA Chase an FM antenna that is appropriate to the local reception conditions. Consider the distances from the broadcast station and possible interfering objects such as surrounding tall buildings.
FRONT PANEL PARTS — AND FUNCTIONS ® FRONT PANEL @ POWER SWITCH This is a “push-on, push-off” type power switch.
© BASS CONTROL Used to control the bass response. A flat response is obtained at the Fiat position. The bass effect is emphasized when the control! is rotated to the right and attenuated when rotated to the left, ® TREBLE CONTROL Used 10 control the treble response. A fat response is obtained at the Flat position. The treble effect is emphasized when the control is rotated to the right and attenuated when rotated to the left.
H—I D LISTENING TO A PROGRAM SOURCE LISTENING TO FM BROADCASTS St the Input selector to FM, Set the Tape Monitor switch to Source Next, set the i Muting/Mads switch to Testosterone (2 4. Rotate the tuning knob s that the tuning indicator fines up with the frequency of the desired station. Adjust sa that both of the tuning indicator green LED fight with equal brightness.