RACK MOUNT REPEATER VXR-9000V-H VXR-9000U-H OPERATING MANUAL VXR-9000V-H / VXR-9000U-H FM REPEATER OPERATING MANUAL
VXR-9000V-H / VXR-9000U-H FM REPEATER OPERATING MANUAL
INTRODUCTION The VXR-9000x-H is commercial-grade 100-watt FM repeater designed to provide reliable two-way full-duplex communications over a wide range of environmental conditions. Designed to mount in a standard 19-inch rack, the VXR-9000x-H is crafted using the latest computer-aided design and manufacturing processes, to ensure a high level of reliability to users.
FRONT PANEL CONTROLS & CONNECTORS POWER (O/I) Switch This is the main power switch for the repeater. Power Indicator (MAIN) This LED glows green when the main power source is used. Power Indicator (BACKUP) This LED glows red when the backup power source is used. MIC Jack Connect the microphone plug to this jack. This jack is also used for writing and reading channel frequency or other configurations via the COM Port of the PC on which the clone editor (CE60) is running.
REAR PANEL CONNECTORS TX Antenna Jack This N-type coaxial jack provides the transmitter output signal, for connection to the transmitting antenna, or the “TX” jack on the duplexer. The output impedance requirement is 50 Ohms. Backup Power Source Terminals If available, a backup 13.6 Volt power source, such as a rechargeable battery, may be connected here.
INSTALLATION Antenna Considerations Equipment Location Repeater operation requires two antennas, one for receiving and one for transmitting, so that the receiving antenna does not absorb energy from the transmitting antenna. There are a number of ways to do this, depending on the TX/RX frequency separation, and on the locations available for antenna mounting.
INSTALLATION Power Supply Backup Power Supply Operation of the VXR-9000x-H requires a power source capable of providing at least 30 Amps continuously at 13.6 Volts DC. Please prepare the regulated power supply which satisfies the above voltage and current specifications. For uninterrupted operation during power failures, a 12-volt rechargeable type battery (55-Ah or more recommended) may be connected to the BACKUP terminal posts on the rear panel.
NOTE Page 6 VXR-9000V-H / VXR-9000U-H FM REPEATER OPERATING MANUAL
NOTE VXR-9000V-H / VXR-9000U-H FM REPEATER OPERATING MANUAL Page 7
NOTE Page 8 VXR-9000V-H / VXR-9000U-H FM REPEATER OPERATING MANUAL
Part 15.21: Changes or modifications to this device not expressly approved by Vertex Standard could void the user’s authorization to operate this device. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
VERTEX STANDARD CO., LTD. 4-8-8 Nakameguro, Meguro-Ku, Tokyo 153-8644, Japan Copyright 2011 VERTEX STANDARD CO., LTD. All rights reserved. No portion of this manual may be reproduced without the permission of VERTEX STANDARD CO., LTD.