User Guide

1
3
The camera needs to be connected to a reverse light. The connection
provides power to the camera, and to notify when the vehicle is in reverse.
Determine the best route for the camera cable from the top of your license
plate to the inside of the vehicle. You may need to drill a small hole.
Run the camera cable through to the inside of your car to the tail light
housing.
At your taillight, remove the light bulb socket from the reverse light housing.
Determine the reverse light power wires for your car, designating the
positive and negative wires.
Connect the camera cable to the power wires of your car using the snap lock
splice connectors. Connect the camera’s red wire to reverse light’s positive
wire. Connect the camera’s black wire to reverse light’s negative wire.
Use pliers to squeeze the metal tabs then snap the plastic cover closed.
Remove the license plate.
Standing with the license plate in one hand and the camera in the other
hand, slide the camera along the top of the license plate.
Peel o the lining to the double-sided tape already attached to the camera
and press rmly to the license plate to secure the camera.
Attach the license plate to the vehicle.
Adjust the vertical angle of the camera.
Power the monitor and check for successful installation prior
to tucking away the cable and putting together your tail light housing.
Stick on back of plate
Backup Camera
Windshield
4
5
1
2
3
4
Hook the monitor to the suction cup mount and attach to windshield.
Power using the 12/24v adapter provided.
Remove overlay and adjust angle as needed.
5
Installation video’s are available on www.letsyada.com to see step by step
installation instructions.
Detailed instructions and warnings can be found in the User's Manual provided.
Note: Camera installation on diesel vehicles may require dierent wiring install.
Reverse Light Power Wires
Camera Cable
2
For more information, please visit: www.letsyada.com or email us at [e-mail]
Winplus North America | 820 S. Wanamaker Ave., Ontario CA 91761 | 866.294.9244
QUICK INSTALLATION GUIDE
for Backup Camera with Dash Monitor