Installation Guide

Stainless Sink Installation Guide

1. UNPACKING AND INSPECTION

Unpack the new sink and check the contents of the materials supplied: (1) Sink, (10) Mounting

brackets, (1) Cut-out template.

2. CHOOSE AN INSTALL METHOD

Supplied with each Zero Edge and Stratus Sink is a cut-out template. This template offers three

mounting installation options:

PAGE 1
Stainless Sink Installation Guide 1. UNPACKING AND INSPECTION Unpack the new sink and check the contents of the materials supplied: (1) Sink, (10) Mounting brackets, (1) Cut-out template. 2. CHOOSE AN INSTALL METHOD Supplied with each Zero Edge and Stratus Sink is a cut-out template.
PAGE 2
3. APPLY YOUR TEMPLATE Place the supplied cut-out template in the desired position on the countertop, allowing extra space for faucet holes and optional fixtures 4. CUT OUT YOUR TEMPLATE Trace the outline of the template onto the countertop along the inside of the line you have designated as your install method. Then cut the countertop on the traced line with an appropriate cutting device. Please note that the supplied template is to be used as a guide only.
PAGE 3
8. ALIGN SIN Position and align the sink over the countertop opening and press the sink onto the countertop. Turn the bent end of the mounting bracket to snug over the sink rim. (Figure 6) 9. DOUBLE CHECK & FINISH Check alignment of the sink again and tighten fasteners to completely secure the sink. Wipe away excess silicone caulk with a damp cloth. Connect the drain and water supply according to the manufacturer’s instructions.