LP-8627M 802.11 B/G/N(1T1R) Wifi module USER MANUAL 1.0.
1. Overview LP-8627M Wireless LAN USB Module is a perfect combination of both performance and cost-effective product introduced. It is sincerely hoped that you can enjoy the wireless world through this solidly profiled wireless adapter. It provides a full solution of all the IEEE 802.11 b/g/n protocols, that pass the WiFi tests and are compatible with all the wireless products with WiFi logo.
2. Product Spec Standards IEEE802.11b/g/n Antenna interface IPEX connector Chip Set Realtek RTL8188CUS Frequency Band 2.400~2.484 GHz unlicensed ISM band Modulation Technology Orthogonal frequency division multiplexing(OFDM), Direct Sequence Spread Spectrum(PBCC,CCK,DQPSK, DBPSK) 802.11b：11,5.5,2 and 1 Mbps with auto-rate fall back Data Rate 802.11g：54,48,36,24,18,12,9 & 6 Mbps 802.11n：(20MHz) ：up to 72 Mbps 802.11n：(40MHz) ：up to 150 Mbps Sensitivity -94dBm @802.11b/-88dbm @802.
3. Pin Configurations 4. Software Installation Step 1: Software Installation Insert product CD to your PC. At the welcome screen, please click “Driver Installation” to install the device driver & utility. If you do not see the welcome screen, go to Start > My Computer and click to open CD-ROM drive. Then double click autorun.exe and wait a few seconds for the welcome screen to show up.
Step 2: Restart your computer Once the installation is finished, click Finish button to restart your computer. Step 3: Connect the USB adapter Plug the USB Dongle into a USB port on your Laptop or Desktop computer. Step 4: Connect to Wireless Network To connect to a wireless network, double click on the Wireless Utility icon in the system tray or on the desktop.
Icon in system Tray Icon on Desktop Click on Available Network tab to view all the access points within range of the adapter. Double Click on the Access Point’s SSID to join the network. If the wireless Network you selected requires security, the utility will guide you through the appropriate security setup. Available Network tab After the signal strength is indicated, you have successfully set up your wireless network on your PC or Laptop.
General tab Unable to connect to a wireless network? 1. Ensure that the LEDs of your router are correctly lit. Check whether your Wireless LAN settings (e.g. SSID, Channel Number) are the same as the routers. Check whether you use the same encryption key (e.g. WEP or WPA) for both Dongle and the router. 2. Make sure that your USB Dongle is correctly installed. Check that your Dongle is plugged in properly to the USB port or try to plug the Dongle into another USB port if available.
5. Hardware Installation ➢Connect the on board connector with pin header module.
Federal Communication Commission Statement (FCC, U.S.) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Custom design antennas may be used, however the OEM installer must following the FCC 15.21 requirements and verify if new FCC approval will be necessary. End product labeling: This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm may be maintained between the antenna and users. The final end product must be labeled in a visible area with the following: “Contains FCC ID: V4FYCBLHD6”.
