BLUETOOTH WIRELESS STEREO SPEAKER WOOMBOX USER MANUAL PLEASE READ THIS USER MANUAL COMPLETELY BEFORE OPERATING THIS UNIT AND RETAIN THIS BOOKLET FOR FUTURE REFERENCE.
IMPORTANT SAFETY INSTRUCTIONS When used in the directed manner, this unit has been designed and manufactured to ensure your personal safety. However, improper use can result in potential electrical shock or fire hazards. Please read all safety and operating instructions carefully before installation and use, and keep these instructions handy for future reference. Take special note of all warnings listed in these instructions and on the unit. 1.
IMPORTANT NOTES Avoid installing the unit in locations described below: • Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters. • • Places subject to constant vibration. Dusty, humid or moist places. NOTE: This product is not magnetically shielded and may cause color distortion on the screen of some TVs or video monitors. To avoid this, you may need to move the unit further away from the TV or monitor if unnatural color shifts or image distortion occurs.
PROTECT YOUR FURNITURE This model is equipped with non-skid rubber 'feet' to prevent the product from moving when you operate the controls.These 'feet' are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a rubber residue on the furniture.
1. 2. 3. 4. 5. 6. 7. 8.
CHARGING INSTRUCTIONS This unit operates on a built-in Li-Polymer battery that can be recharged either using the USB port on your computer or from a USB power adaptor (not included) with a rated output of DC 5V, 1000mA. Note: The DC input jack located on this unit is mainly designed for charging the builtin Li-Polymer battery. The unit will still operate normally while charging, but doing this may reduce the battery life. CHARGING THE BATTERY 1.
TURNING THE SPEAKER POWER ON/OFF 1. In standby mode, tap the POWER button to turn on the unit, the power button backlight will light up green and begin blinking slowly. 2. In power on mode, tap the POWER button to turn the unit off, the green power button backlight turns off. Note: Before first use, please charge the speakers for at least 4 hours because the batteries may not fully charged, even though the charging LED lights.
5. Press the Volume Up (+) / Down (-) button to adjust the desired volume level. 6. To turn off the WOOMBOX Bluetooth, press and hold the Bluetooth button for about 3 seconds until a beep sound is heard and the Bluetooth button backlight flashes red and then all lights go off. Don’t forget to also turn off the Bluetooth feature on your mobile phone. Notes: 1.
Redialing the last number with the WOOMBOX The WOOMBOX will automatically redial the last number you dialed by tapping the WOOMBOX Bluetooth button twice. Hang up with the WOOMBOX A quick press on the Bluetooth button will end the call in progress. A short beep tone will be heard from the WOOMBOX confirming the call ended. Re-linking to the mobile phone If your mobile phone is already paired with the WOOMBOX, but became unlinked even with both Bluetooth devices turned on. You can re-link them by: 1.
NOTES: (1). If you’re connected to the Line Out Jack of your external device then you only need to adjust the volume control on the WOOMBOX. If you’re connected to the Headphone Jack of your external device, then you may need to adjust both the volume control of your external device and the volume control on the WOOMBOX to find the most desirable volume setting. (2). If you use AUX IN function in Bluetooth on mode, Bluetooth audio will be temporarily disconnected when the audio cable plugged in.
2. To prolong the life of a rechargeable battery, it is recommended to completely discharge it before fully charging it again. 3. Rechargeable batteries need to be cycled for maximum performance and longer battery life. If you don’t use the player that often, be sure to recharge the battery at least once a month in order to keep the internal battery working properly. Remarks: Quick flashing implies the LED lights up for 1 second and shuts off for 1 second.
TROUBLESHOOTING GUIDE Symptom No Charging Possible Problem Solution AC Adaptor is not plugged into a wall outlet or the connector is not plugged into the power supply jack on the back of the unit. Wall outlet is not functioning. Computer USB port is not functioning. Plug the AC adaptor into a wall outlet and plug the connector into the supply jack on the unit. Plug another device into the same outlet to confirm the outlet is working. Make sure your computer power is turned on and try another USB port.
SPECIFICATIONS Bluetooth : v 2.1 Wireless Receiving Distance : 10M / 33FT Bluetooth Profiles : A2DP , HFP , HSP Advanced Audio Distribution Profile (A2DP) for wireless music streaming. Hands-Free (HFP) and Headset Profiles (HSP) for Hands-Free speakerphone. Hangs-Free Speaker for Bluetooth phone. Built-in Microphone. Audio Input : AUX-IN 3.5mm. Connect your iPod, MP3, Digital Audio Player. Audio Cable included. Audio Output Power : 1.
