X-Brain(V2) Quick Start User Manual Signal Bar www.xunison.
To setup X-Brain ,connect 1) Power cable, 2) Ethernet cable(if applicable).
Android/iOS Application Download and Install X-Home application from the Playstore/Appstore
Step 1:Open X-Home application, Press “Register”.Enter registration details.
Step 2: Enter Registered email address and password to “Login”.
Step 3: To add New Gateway, press “Add New Home”. Scan QR- Code printed on the label at the bottom of the gateway.
Step 4: Press on the Gatway UID. Enter the name of your Gateway.
Step 5: New Home Gateway added, press on the Gateway. Choose default timezone.
Step 6: Enter the router admin password given on the label printed at the bottom of your Gateway.
Step 7: From here you can select either router mode (Connect Ethernet from ISP router to WAN port)or repeater mode(Connect wirelessly to your existing ISP device).
Step 8: Press “SCAN” and select the Wi-Fi SSID to setup the repeater mode
Step 9: Enter the Wi-Fi SSID and the password. press “Finish Setup” Note: If you have setup repeater mode,disconnect the ethernet cable from the X-Brain device once the setup is complete.
Step 10: Once the setup is complete,select your Gateway.
FCC Caution: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.