1. what’s in the box Please consult below checklist for all the components. USB Cable Video Doorbell User Guide Indoor Chime Screw & Tools Adhesive Tape 2.
4. Battery installation isolating film The batteries are pre-installed in the doorbell, with an isolating film inserted in the positive poles. Please remove the film and insert the battery pack back to compartment, with positive poles upward! NOTE: Improper battery installation will cause damage to the internal components and may result in serious injury. 5. Battery charging The batteries inside the doorbell are not fully charged in accordance with transportation safety regulations.
Guiding steps: 9:55 9:55 9:55 Devices Camera Doorbell Battery Camera Floodlight Camera 9:55 Install Doorbell Install Doorbell Please follow the instruction manual to power the device Press the [Bell] button, and tap Next Help this) · Wait for the LED indicator to flash RED Network Video Recorder · Tap Next Next Next Devices Messages Next Me 1. Tap “+” to add device 9:55 2. Select Doorbell 3. check power status 9:55 Wi-Fi Setup 15~25cm (Please select a 2.
9. Live view 1 2 3 4 5 6 7 Quit live viewing Setting menu Battery status Volume on/off Speak to the scene HD/SD switch Notification history Wi-Fi signal status Stream bit rate 8 9 10 11 12 13 14 Wi-Fi signal status Screenshot button Speak to the scene Record on the phone Body detection on/off Notification history Cloud storage service HD Live view interface 10. Playback If the Micro-SD card is properly installed, you can playback the video clips taken after detected motions or visitor calls.
11. leave Voice messages Maximum 3 voice messages (Max. 10 seconds each) can be pre-recorded into the doorbell, which enables you to quickly respond to your visitors when you are not convenient to answer the doorbell call.
Share by QR code scanning The new users can show their QR codes to the administrator, and share device by QR Code scanning.
Pair with doorbell 1). Tap on “···” and enter into Settings-> Basic function, select Wireless Chime page.(refer to Picture.4) Settings Wireless Chime BasicFunction Night Vision Automatic Chime Reminder t se Re Host Leaves Message Receive Notifications Wireless Chime Device Share Power Management Picture.5 Ring Volume Device Information Middle Basic Function Chime Pairing Alarm Setting One-button untie SD Card Cloud Storage Service Device Version Delete Device Picture.1 Picture.
14. Installation 166° Select location Your doorbell has 166-degree view angle and 120-degree human detection range. It is suggested to mount your doorbell at least 5 feet (160 cm) above the ground for the best angle of view and motion detection performance. 5 feet 160cm Hardwire your doorbell (Optional) If replacing an existing doorbell, please shut off the power breaker in advance, and remove it from the wall and disconnect the wires. Our doorbell works with both 12V - 24V AC and 12V DC power source.
Go wireless installation The Smiths (Example) 1. Dismount the bracket by pushing from the back of your doorbell. Please remove the insulation film in the battery cell. 2. Bracket installation: mount the bracket on the wall with screws & anchors or the double -sided adhesive tape. 3. (Optional) The nameplate holder can be mounted on the top rear/ bottom rear of the bracket, prior to bracket installation. The Smiths 4. Mount your doorbell to the fixed bracket.
14. Specification Video doorbell Indoor Chime Video & Audio Image Sensor General 1/2.7” CMOS (2.0MP) Hisilicon Lite-OS Power source DC 5V 1A OS Power port USB (Type-A) Resolution 1920 × 1080 px Consumption 0.2W Stream HD/SD dual stream Ringtones 4 ringtongs optional Infrared LED High power IR LED with ICR Volume Max 100dB Lense 1.7mm/F2.0 Volume control Low(mute), middle, high Angle of view 166° Connection type Radio frequency Min. illumin. Color: 0.01 Lux; B&W: 0.
15. Trouble shooting Q1: Why I failed to set up Wi-Fi for the doorbell? A1: ①.Device works with 2.4GHz Wi-Fi only, but not support 5GHz Wi-Fi. ②.Wi-Fi network is not good, try to keep the camera near the Wi-Fi router when setting up. ③.The Wi-Fi password is wrong. Please check if there are special characters in the password, or the network is specially encrypted. Q2: How do I know if I have 2.4G or 5G wifi? A2: Please check the user manual of your Router or call the network operator for help.