20 IN.
SAFETY INFORMATION WARNING 1. Read and save these instructions. Do not operate fan unless you have read these instructions. 2. Unplug the fan before moving it or performing maintenance. Do not touch the fan when your hands are wet. 3. Those who are not qualified electricians should not disassemble, repair or rebuild the fan. 4. Unplug the fan when it is not in use. 5. DO NOT unplug the fan by pulling the cable cord. Unplug by holding the plug and pulling. 6.
ASSEMBLY INSTRUCTION 1. Mark the hole locations by using the brackets, then drill the holes. A. For concrete wall installation, after drilling, you would insert the wall anchors and tap them flush with the wall, position the bracket and then screw the two bolts into the anchors, securely attaching the wall. B. For wall stud installation, after drilling the smaller diameter pilot hole, position the bracket and screw the two bolts into the wall until they are secured.
ASSEMBLY INSTRUCTION (CONTINUED) 2. Insert the Upper Bracket into Motor Frame by screws as follow: Firstly, No.1 screw M8 18 match No.4 Hexangular Nut. Secondly, No. 2 screw M8 20 match No.5 Washer Nut M8. Finally, the Upper Bracket No. 3 will fix into Motor frame. 3. Assemble the Upper Bracket with the wall bracket by screws as follow: Firstly, insert No. 1 Screw M12 100 through the Upper Bracket Secondly, connect the Lower Bracket with Upper Bracket by No. 1 Screw Finally, fasten two bracket by No.
OPERATION INSTRUCTION 1. Place the fan on a safe, flat surface where it can not fall or be pulled by the cord. 2. Adjust the desired speed by pulling the chain switch (Stop - Low- Medium - High). CARE AND CLEANING Unplug the appliance before cleaning. Do not use water for cleaning metal surfaces. Slightly moisten a cloth and wipe off the surfaces of the fan. In order to remove dust from the grill, use a vacuum cleaner or remove the front grill by removing the securing screws on the edge of the grill.
IO PRODUCT MADE IN CHINA 5