Instructions / Assembly

Installation & Assembly Instructions
Please contact our Customer Service Division with any questions at:
30700 D Carter Street ∙ Solon, OH 44139 ∙ (P) 440.248.5480 ∙ [e-mail]
For a full line of products visit www.tritonproducts.com
Read all instructions completely before installing. Should you have any questions about your
installation, please call Customer Service at 440-248-5480
NOTE: All systems must be secured to structurally sound, flat walls
Step 1. Remove all parts from carton and inventory all components.
Parts Inventory
(2) Panel frame sections 48”W x 48” H black (55” Wide @ arm extensions)
(4)Sheets of ¼” tempered pegboard with 1” on center (O.C.) hole spacing
(2) Wall mount angle plates 3” x 3” x 4” long.
(4) 3/4" x 1-3/4” Phillips flat head masonry screws (for wall mounting angle
attachments)
(2) 3/8”-16 x 2-1/4” hex head bolt (pivoting pins)
(4) 3/8” Flat washers (for pivoting pins)
(4) 3/8”-16 Hex head nuts (for pivoting pins)
(2) 3/8” Lock washer (for pivoting pins)
(56) Self tapping truss screws with #2 Phillips head (for tempered pegboard attachment)
(2) 5/16”-16 x 3” Hex head bolts (for attaching frame sections together)
(4) 5/16” Flat washers (for attaching frame sections together)
(2) 5/16” Lock washers (for attaching frame sections together)
(2) 5/16” Hex head nuts (for attaching frame sections together)
(4) Plastic end caps
Step 2. Attaching frame sections together: With frame sections lying flat, arm sections pointing in the
same direction, align the two pre-drilled holes of each section. (Refer to figure 1-1). Using the (2) 5/16”-
16 x3” hex head bolts, slide one 5/16” flat washer onto each bolt and insert through the aligned holes of
both frame sections. Slide a second flat washer on to each bolt and then a 5/16” lock washer. Secure
each bolt using 5/16”-16 hex nuts. (Avoid over-tightening and crushing tubular frame)
Step 3. Pivoting bolt attachment to arm assemblies: (Refer to figure 1-2 close-up.) Using 3/8”-16 x 2-
1/4” hex bolts, slide (1) 3/8” washer onto bolt and then insert bolt with washer through hole in arm
assembly. Once through arm assembly, install another flat washer and secure using (1) 3/8” hex nut by
hand tightening. Repeat steps for second arm.
Step 4. Attaching tempered pegboard to each side of frame: Using the existing holes in pegboard and
#10-3/4” self-tapping screws. Square up pegboard with the outside edge of your frame section. Using an
electric drill with a high performance #1 or #2 Phillips bit, install self-tapping screws into each of the
corners opposite arm assemblies; complete installation using (figure 1-1 for tap screw layout. Repeat
step for other side. To help expedite installation of your pegboard: You may want to pre-drill where tap
screws are to be installed using a 1/8”drill bit.
D1 - 48x48 XtraWall® Swing Pegboard