Third Party Verification Claim

IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a
combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the
supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in
the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product
acceptance by Authorities Having Jurisdiction.
This listing period is based upon the last date of the month indicated on the Effective Date and Void After Date shown above. Any change in material,
manufacturing process, marking or design without having first obtained the approval of the Product Certification Committee, or any evidence of
non-compliance with applicable codes and standards or of inferior workmanship, may be deemed sufficient cause for revocation of this listing.
Production of or reference to this form for advertising purposes may be made only by specific written permission of IAPMO Research and Testing, Inc.
Any alteration of this certificate could be grounds for revocation of the listing. This document shall be reproduced in its entirety.
This certificate is not evidence of current listing. To verify listing status, visit the IAPMO R&T
Product Listing Directory at pld.iapmo.org
Effective Date: May 2019 Void After: May 2024
Product: Bathtubs (Plastic) File No. 11725
Issued To: Munk Building Materials Co., Ltd.
Rm. 1903, Bdg. T8, Smart City,
No. 28 Jihua 1st Rd.,
Foshan, GUANGDONG
China
Identification: Manufacturer's name or trademark, or both, shall be permanently
and legibly marked on the unit so as to be visible after installation. The
product shall also bear the cUPC® certification mark.
Characteristics: Plastic bathtubs with or without walls and with right or left hand or
center outlets to be installed in accordance with the manufacturer's
instructions affixed to the unit and the requirements of the latest
edition of the Uniform Plumbing Code®.
Bathtubs without factory applied nailing flanges are listed as drop-in
units only, and are not to be installed against the wall. Bathtubs
intended for installation against a wall shall incorporate an integral,
factory applied or field applied nailing flange in accordance with
this standard.
Chancheng District,