Third Party Verification Claim
IAPMO Research and Testing, Inc. is a product certification body which tests and inspects samples taken from the supplier's stock or from the market or a
combination of both to verify compliance to the requirements of applicable codes and standards. This activity is coupled with periodic surveillance of the
supplier's factory and warehouses as well as the assessment of the supplier's Quality Assurance System. This listing is subject to the conditions set forth in
the characteristics below and is not to be construed as any recommendation, assurance or guarantee by IAPMO Research and Testing, Inc. of the product
acceptance by Authorities Having Jurisdiction.
This listing period is based upon the last date of the month indicated on the Effective Date and Void After Date shown above. Any change in material,
manufacturing process, marking or design without having first obtained the approval of the Product Certification Committee, or any evidence of
non-compliance with applicable codes and standards or of inferior workmanship, may be deemed sufficient cause for revocation of this listing.
Production of or reference to this form for advertising purposes may be made only by specific written permission of IAPMO Research and Testing, Inc.
Any alteration of this certificate could be grounds for revocation of the listing. This document shall be reproduced in its entirety.
This certificate is not evidence of current listing. To verify listing status, visit the IAPMO R&T
Product Listing Directory at pld.iapmo.org
Effective Date: October 2019 Void After: October 2024
Product: Bathtubs (Plastic) File No. 10317
Issued To: Xuancheng Ods Sanitary Ware Co., Ltd.
Hanting Branch, Xuanzhou
Economy Development Area
Xuancheng, ANHUI
China
Identification: Product shall be marked with the manufacturer's name or registered trademark
or, in the case of private labelling, the name of the customer for whom the
fixture was manufactured. Markings shall be permanent, legible, and visible
after installation. Fixtures that do not comply with one or more of the
dimensional requirements shall be marked with an "N" to indicate the
non-standard nature of the fixture. Bathtubs that use field-installed
flanges shall have a non-permanent label stating "Do not install this fixture
against a wall unless the appropriate flange is first installed". (The
equivalent French wording is "Ne pas fixer cet appareil au mur a moins que la
bride appropriee n'ait ete prealablement installee"). The product shall also
bear the cUPC® certification mark.
Characteristics: Plastic bathtubs with or without walls and with right or left hand or
center outlets to be installed in accordance with the manufacturer's
instructions affixed to the unit and the requirements of the latest
edition of the Uniform Plumbing Code®. Bathtubs without factory applied