Safety Instructions

ManualsBrandsXotik ManualsElectronicsTRANSMITTER

Table Of Contents

XOTIK XTX200 2.4GHz Radio Control System

Instruction Manual

IMPORTANT! Read the ENTIRE instruction manual to become familiar with the features of the product

before operating. This manual contains instructions for safety, operation, and maintenance. It is

essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or

use, in order to operate correctly and avoid damage or serious injury.

NOTICE: All instructions, warranties, and other collateral documents are subject to change at the sole

discretion of XOTIK. For up-to-date product literature, please visit www.xotikmodel.com.

FEATURES

 2.4GHz Spread Spectrum Technology

 Built in failsafe function

 Push button steering trim

 Ergonomic drop wheel design

Summary of content (6 pages)

PAGE 1
XOTIK XTX200 2.4GHz Radio Control System Instruction Manual IMPORTANT! Read the ENTIRE instruction manual to become familiar with the features of the product before operating. This manual contains instructions for safety, operation, and maintenance. It is essential to read and follow all the instructions and warnings in the manual, prior to assembly, setup or use, in order to operate correctly and avoid damage or serious injury.
PAGE 2
SPECIFICATIONS XTX200 TRANSMITTER XRX200E RECEIVER Channels: 2 Frequencies: 2.405 – 2.475GHz Modulation: FHSS spread spectrum Input Power: 2.20 – 3.0V DC Output Power: <0.1W Power On Indicator: LED Channels: 2 Frequencies: 2.405 – 2.475GHz Modulation: FHSS spread spectrum Input Power: 2.9 – 4.2V DC Power On Indicator: LED SAFETY PRECAUTIONS           IMPORTANT! Always follow these instructions when operating this system. Do not modify or alter this system.
PAGE 3
FCC STATEMENT This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. FCC Rf Radiated Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
PAGE 4
Remove the safety screw and press the lever at the base of the handle to swing open the battery door. Install the two batteries according the orientation stated inside the battery compartment. After battery installation, close battery door and tighten safety screw. Press in the power button on the top of the transmitter. The LED around the power button will glow after power on. If not, power off the transmitter and re-check the installation of batteries.
PAGE 5
POWERING THE SYSTEM IMPORTANT! Always power on the transmitter first, then power on the receiver. Always power off the receiver first, then power off the transmitter. Never power off the transmitter while running the model. CARE AND MAINTENANCE     After each run, examine all parts for damage. If any is found, do not operate until the damage has been repaired. Use a clean cloth to wipe the transmitter clean. Keep the transmitter and battery away from direct sunlight and/or heat sources.
PAGE 6
FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.