PORTABLE ANTENNA SYSTEM XORO MPA 38 INSTALLATION AND OPERATING MANUAL
GENERAL.....................................................................................................................3 SAFETY INSTRUCTIONS..........................................................................................3 PACKING LIST ............................................................................................................3 SET-UP LOCATION .................................................................................................... 4 CONNECTION SCHEME................
GENERAL The portable Antenna System is designed to be used for receiving and watching satellite broadcasting in any outdoor environments. Once you have made all the connections and start the system, it can automatically find the satellite and set the connection for your satellite receiver. Note: Not suitable for the reception of the encoded Swiss TV-channels SRF1, SRF2 etc. SAFETY INSTRUCTIONS Do not open the cover of the unit. No user-serviceable parts inside.
SET-UP LOCATION Make sure there are no physical obstacles between the antenna and line of sight to satellite which may prevent to get the signals. Any tall objects will block the signal. The antenna unit requires “direct line of sight” to satellites for optimal signal reception. The signal receiving performance of the system may decrease during heavy rainfall or snowfall. It also happens if the antenna is covered by snow. In such case, remove gently the snow off the antenna.
INSTALLATION 1. 2. Make sure the control box is switched off while connecting all the cables. Use the RG-6 coaxial (long) cable to connect the antenna unit’s DCR-port with “ANTENNA IN” of the control box. Then use the second coaxial (short) cable to connect “LOOP-OUT” jack of the control box with the LNB/SAT-IN input of your satellite receiver. The loop jack passes the complete receiving signal coming from the satellite to your receiver through or TV set. 3.
FRONT PANEL 1 ON/OFF Switch 2 Power LED Indicator 3 USB LED Indicator 4 USB Port REAR PANEL 1 Loop-out connection for external receiver 2 Antenna-in connection for antenna unit 3 Control panel connection 4 12/24V Power connection
OPERATING INSTRUCTIONS Operating the system Make sure all the connections between antenna system and control box and between receiver and control box using the loop out port are connected properly. Make sure the handle of the antenna points towards the floor while in operation in order to prevent a limited signal reception. Turn on the system “Turn on” the On/Off switch on the front of the control box. The LED on the front panel will turn on and the system will start to operate.
WARRANTY TERMS If the products, at the time of the passing of risk, do not have the agreed quality or otherwise have a defect within, the MAS Elektronik AG shall be entitled to remedy the defect or replace the defect. In the event of defect removal / replacement delivery, MAS Elektronik AG acquires ownership of the removed / replaced components / devices with the expansion / replacement.
Notes
TECHNICAL SPECIFICATIONS Antenna motion: Satellite search: Connection: Azimuth moving range: Elevation moving range: Operating voltage: Operating power consumption: Dimensions (in closed position): Weight: Storage temperature: Operating temperature: Operating relative humidity range: Two axis; azimuth and elevation Automatic at stationary position only Through single coax cable 0° ~ 380° limited 0° ~ 80° 12-24V DC 30W 45x48x46( LxWxH in cm) 5,5 kg -30°C ~ +70°C -15°C ~ +50°C 0 ~ 98 % The manufacturer rese
