Installation and Operations Manual October, 2001 Revision 4.0 © Copyright 2001, EXI Wireless Systems Inc. All rights reserved.
EXI HALO Installation & Operation Manual 981-000003-000R4.0 Table of Contents 1. LIMITED WARRANTY...............................................................................................................................................4 2. RECORD OF CHANGES.............................................................................................................................................6 3. FCC REGULATIONS..................................................................................
EXI HALO Installation & Operation Manual 981-000003-000R4.0 7.5. HALO RECEIVER......................................................................................... ERROR! BOOKMARK NOT DEFINED. 7.6. ELEVATOR CONTROLLER........................................................................ ERROR! BOOKMARK NOT DEFINED. 7.6.1. Pre-Alarm ........................................................................................................Error! Bookmark not defined. 7.6.2. Full-Alarm ...................
EXI HALO Installation & Operation Manual 981-000003-000R4.0 Limited Warranty 1. Warranty: Subject to the limiting conditions set forth below, EXI Wireless Systems Inc.
EXI HALO Installation & Operation Manual 981-000003-000R4.0 limitation on liability described in §5, and agrees to warn, and obtain acknowledgements from, all users thereof of the same. 7.
EXI HALO Installation & Operation Manual 981-000003-000R4.0 1. Record of Changes October 1999 Combined HALO Installation & Operating Manual and Elevator Manual. March 2000 Added Cabling types and Threshold / RX Sensitivity Switch Adjust.
EXI HALO Installation & Operation Manual 981-000003-000R4.0 2. FCC Regulations This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC Rules.
EXI HALO Installation & Operation Manual 981-000003-000R4.0 EXI Wireless Systems CANADA: TBD Model No.: Halo Asset tag FCC ID: HE7 ATG * This device complies with Part 15 of the FCC Rules. Operation is subject to the following two rules: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
EXI HALO Installation & Operation Manual 981-000003-000R4.0 The R3 Controllers have unique serial numbers that are associated with the location that they serve. Ensure that the correct Controller Serial Number is used at the location being entered on the floor plan in the computer! 4.5. INSTALLING RECEIVERS Receivers are meant for use where only a Tag Initiated Communications (TIC) signal needs to be detected.
EXI HALO Installation & Operation Manual 981-000003-000R4.0 Receivers have unique serial numbers that are associated with the location that they serve. Ensure that the correct Receiver is used at the location being entered on the floor plan in the computer! Figure 3 – HALO Receiver Settings 4.5.1 THRESHOLD SWITCH The Threshold switch may be adjusted to increase or reduce the sensitivity of the Receiver and therefore the range of detection of the Tag.
EXI HALO Installation & Operation Manual EXI Wireless Systems 981-000003-000R4.