Installation Guide

Part Number 806A2901
808 Commerce Park Drive, Ogdensburg, NY 13669 USA or
309 Legget Drive, Ottawa, ON K2K 3A3, Canada
Telephone: [phone] Facsimile: 1-613-592-4296 Web Site: www.xmarksystems.com
© 2003 Instantel Inc. All Rights Reserved. Instantel and Hugs are registered trademarks of
Instantel Inc. in North America. The hearts logo and Xmark are trademarks of Instantel Inc. Xmark
is a division of Instantel Inc. Printed in Canada. December 2003. 806U2901 Rev 01A.
Certifi ed to the ISO 9001 Quality Standard
Materials Required
• FindIt
®
Locator (p/n 806A2901)—includes AC power adapter,
two antennas, mounting plate with screws, and stand.
• Suitable mounting hardware (not supplied)—for mounting
Locator to a vertical surface, such as a cart: screws, double-sided
tape or cable ties.
Installation Considerations
• Position the Locator vertically with the antennas pointing
upwards—The supplied stand angles the Locator at approxi-
mately 70°. Do not mount the Locator at a lower angle if mount-
ing to a solid surface, and never lay the Locator fl at.
• Keep the antennas away from metal—If mounting the Locator
to a metal cart, ensure that the antennas project above the frame
of the cart. Do not lean the Locator against a metal object.
• For best performance, place the Locator in an unobstructed
location—Where possible, keep the Locator away from the body
or large objects.
• Performance may not be optimal while the Locator is being
charged—The Locator continues to operate while the batteries
are charging, but performance may not be optimal. Keep the
power cord away from the antennas to improve performance.
• Observe temperature and humidity restrictions—Refer to the
Specifi cations table.
• No user adjustments to internal circuitry—Tampering may
cause component or system failure, or both, and will void the
warranty.
Important Reference Documents
• FindIt Portable User Manual
Read these instructions thoroughly
before installing the FindIt Locator.
Faulty installation can lead to system failure.
!
Materials Required
Specifi cations
Installation Considerations
Important Reference Documents
Locator Installation Guide
Figure 1: The Locator with antennas attached
Frequency 217 MHz
Supply Voltage 12 VDC, 800 mA
Batteries Two 3.6 V lithium-ion rechargeable
Battery Life 24 hours when fully charged
Detection Radius Up to 35 ft. (11 m)
Communications LonWorks 2 wire
Temperature - operating 32° to 113°F (0° to 45°C)
Temperature - storage -22° to 158°F (-30° to 70°C)
Humidity 0 - 90% RH @ 70°F (21°C), non-condensing
Dimensions Approx. 6.3 x 3.5 x 1.5 in. (159 x 89 x 38 mm)
Weight (with antennas) Approx. 15.9 oz. (452 g)