XT-4850C User Guide Model: XT-4850C FCC ID: GKM-XT4850C IC: IC: 10281A-XT4850C Version 2 1
Table of Contents Document Change History .......................................................................................... 3 1 Introduction ............................................................................................................ 4 1.1 Feature Matrix................................................................................................................................................................................. 4 2 Hardware Description ............................
Document Change History Revision 1.
1 Introduction XT-4850C is an energy harvesting global multi-band 3G platform supporting long term, remote deployments without the need to replace the self-charging battery. This installation guide describes the physical hardware, associated parts, the different mounting options available, and a quick start-up procedure. 1.
2 Hardware Description Below is a depiction of key interfaces of the XT-4850C: Wake-up/ Zigbee Pairing Button Zigb Device Label 7-Pin Bayonet Connector Solar Panel LED Indicators The Associated Cable Harness that interfaces with the unit is shown below: 5
2.1 Hardware Specifications Technology Model Frequency Band GPS Specification Receiver 50 channels Receiver tracking Sensitivity Accuracy Cold Start Hot Start Power Requirements D.C. Power Battery Physical Connection Interface Connector Cellular/GPS Antenna SIM Access Programming Mechanical Case Material Dimension Weight Operating Temperature Certifications Product Carrier CDMA 1xRTT XT-4850C Dual-band Support: 850/1900 50 channels -161 dBm +/- 2.
2.2 Cable Harness Description Pin # Wire Color 1 2 White IN1 Black Green Ground Out Yellow 3 4 5 Pin Name Blue IN2 UART-Rx 6 Brown UART-Tx 7 8 Red Orange VBATT ADC Functional Description Port Characteristic Ignition Sense Input port 8v to 24v, Internally pulled low 2.4 to 24V, < 0.2 V Note: Internally pulled high Ground Output Port (Defaulted open circuit) External battery negative terminal Main battery voltage, DC Analog Input 3.
3 Device Mounting Options 3.1 Screw Mounting The XT-4850C has two flanges (two holes per) at each end of the housing for screw mounting the device to the mounting surface. 3.2 Magnetic Mounting The XT-4850C can also be equipped with magnets which support a load up to 10kg.
Quick Start Guide 4.1 Device Wakeup To start up the device, simply hold the black button located near the circular connector on the side panel of the device for 3 seconds. You should see the blue “C” LED light up and then fade out. The LED will fast-blink when the device is successfully connected to the network.
4.2 Configuring the Device via SMS 1) 2) 3) 4) 5) 6) 7) 8) Ensure your device is active on your cellular account. Awaken device from sleep XT-4850C via the “wake-up” button. If the device needs more power, then supply 12V DC via the red wire of the cable harness. Ensure device cellular LED is blinking based on LED definition in this document.
FCC/IC: REGULATORY COMPLIANCE INFORMATION This equipment with FCC-ID: GKM-XT4850C and IC-ID: 10281A-XT-4850C, Model: XT-4850C is subject to the Federal Communications Commission (FCC) and Industry Canada (IC) rules. NOTICE: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules and with license exempt Radio Standard Specifications of Industry Canada.