XT-4860G2 User Guide Model: XT-4860G2 FCC ID: GKM-XT4820 IC ID: IC: 10281A-XT4820 Version 1.
Table of Contents Document Change History .......................................................................................... 4 1 Introduction ............................................................................................................ 5 1.1 Feature Matrix ................................................................................................................................................................................. 5 2 Hardware Description ............................
Document Change History Revision Date Author Changes 1.
1 Introduction XT-4860G2 is an energy harvesting global multi-band 3G Dual Band platform supporting long term, remote deployments without the need to replace the self-charging battery. This installation guide describes the physical hardware, associated parts, the different mounting options available, and a quick start-up procedure. 1.
2 Hardware Description Below is a depiction of key interfaces of the XT-4860G2: Wake-up/ Zigbee Pairing Button Zigb Device Label Solar Panel LED Indicators 7-Pin Bayonet Connector The Associated Cable Harness that interfaces with the unit is shown below: 6
2.1 Hardware Specifications Technology Model Frequency Band GPS Specification Receiver 50 channels Receiver tracking Sensitivity Accuracy Cold Start Hot Start Power Requirements D.C. Power Battery Physical Connection Interface Connector Cellular/GPS Antenna SIM Access Programming Mechanical Case Material Dimension Weight Operating Temperature Certifications Product Carrier 3G UMTS/HSDPA/HSUPA XT-4860G2 Dual-band Support Band II – 1900 MHz Band V – 850 MHz 50 channels -161 dBm +/- 2.
2.2 Cable Harness Description Pin # Wire Color Pin Name 1 White IN1 2 Yellow IN2 3 4 Black Green Ground Out 5 Blue Functional Description Port Characteristic Ignition Sense Input port 8v to 24v, Internally pulled low 2.4 to 24V, < 0.2 V Note: Internally pulled high Ground Output Port (Defaulted open circuit) External battery negative terminal UART-Rx 3.3V Logic Interface Com Port Settings: Baud rate: 115200 bps; Flow control: None; 8N1 3.
3 Device Mounting Options 3.1 Screw Mounting The XT-4860G2 has two flanges (two holes per) at each end of the housing for screw mounting the device to the mounting surface. 3.2 Magnetic Mounting The XT-4860G2 can also be equipped with magnets which support a load up to 10kg.
3.3 Optional Cradle Mounting An optional mounting cradle can be purchased for easy snap-on/snap-off device mounting for the XT-4860G2. The cradle will need to be screw-mounted on to the position desired.
4 Quick Start Guide 4.1 Device Wakeup To start up the device, simply hold the black button located near the circular connector on the side panel of the device for 3 seconds. You should see the blue “C” LED light up and then fade out. The LED will fast-blink when the device is successfully connected to the network.
4.2 Configuring the Device via SMS 1) 2) 3) 4) 5) 6) 7) 8) Ensure your device is active on your cellular account. Awaken device from sleep XT-4860G2 via the “wake-up” button. If the device needs more power, then supply 12V DC via the red wire of the cable harness. Ensure device cellular LED is blinking based on LED definition in this document.
FCC/IC: REGULATORY COMPLIANCE INFORMATION This equipment with FCC-ID: GKM-XT4820 and IC-ID: 10281A-XT-4820, Model: XT-4860G2 is subject to the Federal Communications Commission (FCC) and Industry Canada (IC) rules. NOTICE: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with Part 15 of the FCC Rules and with license exempt Radio Standard Specifications of Industry Canada.
