Bluetooth car kit C926 27
Content Content………………………………………………….27-29 Welcome to use C926……………………………….............30 Bluetooth hands-free car kit illustration……………….....…31 Using guide Introduction………………………………………………..…32 Charging..……………………………....................................33 How to charge……………………………………………..…34 How to turn On/Off…………………………….................…35 Pair the Bluetooth hands-free car kit with Mobile phone...
How to use the car kit..............……………………………41-47 Assemble the backside clip………………….……….....……..48 Fit the car kit to the sun visor……………………………..48-50 Indicator……………………………………………………. .51 Troubleshooting.........……………………………...………52-53 Care and Maintenance.........……………………………......
Welcome to use Bluetooth hands-free car kit C926 car kit is specially designed for using in a car which offers safe and convenient way while making or answering a call. C926 is a wireless device that can be also used at home or in the office. the surrounding noise can be reduced while communicating because of high-powered circuit design and free-echo, it makes the voice more clear, loud and vivid.
Illustration Microphone speaker charging indicator Multi-function key/ hang up Microphone rocker indicator switch/ UP key volume down State indicator volume up Screen Inversion show /DOWN key answer key / volume control /re-dial power indicate sign 31
Introduction First time to use 1.For the first time you use the car kit with the mobile phone together, you should make sure: The car kit has been charged for 4 hours. The car kit has been turned on. The function of Bluetooth has been turned on.
Charging z When to charge 1.Before using the Bluetooth car kit for the first time, please charge more than 4 hours. 2.While communicating, if you hear the fast warming tone sounds 5 times and repeats every 20 seconds, it means your device need charging.
z How to charge 1.Turn off the power 2.When you are in the car, you can use the original USB car charger to charge the device. *.Charge it until the red indicator of the car kit goes out. *.Fully charged will cost about 3-4 hours. Tip: Without using the device in a car, you can charge the device with these two ways below: 1. Use the suitable wall charger to charge the device (Standard DC5V/500mA charger which sells in the market) 2. Use the original USB cable to charge it by computer. Note:①.
How to turn on/off the Bluetooth hands-free car kit Turn on the car kit Hold the Multi-function key for about 5 seconds, the blue indicator will flash rapidly for three times , when you hear “Di” from the speaker, the screen will be bright and shows “C926”,it means the power has been turned on, it will come into the pairing mode and search the paired device.
Pair with the mobile phone Note:You should pair the Bluetooth hands-free car kit with the mobile phone before using. (“Pairing” creates a link between Bluetooth devices, and allows the mobile phone to store the car kit’s unique ID. When your car kit and Mobile phone are paired, the car kit automatically connects to your phone.
Pairing: Steps B:The blue indicator flashes rapidly for 6 times A: Hold this key more than 5 seconds pairing distance should not over 1M 37
Pair with one mobile phone: 1、Place the car kit and the mobile phone together, when the car kit from off state, hold the Multi-function key until the blue indicator keep showing and after hear a “di” sound from the speaker , the car kit will come into the pair mode. 2、Startup the searching function of your mobile phone, about this function, please see the user manual of Mobile phone for reference, after searching, the mobile phone shows all the devices that have been searched.
Pair with two mobile phones: This device can be paired with two mobile phones, the one which incomes the call first, it will use the car kit first. The second mobile phone can be paired with the same way as the first one, just repeat the steps like the pairing way of the first one is available. Import note:1. After pairing successfully, the indicator flashes every 3 seconds. If it fails, please pair again.
Pair with additional Bluetooth wireless device 1. The car kit can store pairing information for up to eight devices through Bluetooth technology. Devices are stored in a “Paired Device List” in order. When an attempt to pair with more than eight devices, the initial paired device will be removed from the list. 2. Any of the eight paired devices can initiate a connection to the car kit. 3. The car kit will only automatically initiate a connection with the last two paired devices.
Using the Bluetooth car kit Note:If you haven’t paired your car kit with the mobile phone within 10 minutes, your car kit will be turned off automatically to save power. Making a call You can use the mobile phone or the voice to dial the number,then use the Bluetooth hands-free car kit to re-dial easily.
Use the mobile phone to make a call You can dial a number by the keyboard or the address list of the mobile phone. Voice dialing Note:Please startup voice dialing function and record voice order before activating it, you can view the using guide of the mobile phone for reference. 1.Press the volume control key, the screen will show “Voice Dial”. 2.After hearing the sound, activate voice dialing by normal way.
Re-dial 1. Press keys of the mobile phone or activate voice dialing, then you can use the car kit to re-dial easily. 2.Hold the re-dial key for 2 seconds until the screen shows “Redial Last”, then you can re-dial the number. Answer or reject a call 1.Press the answer key to pick up a call after it rings. 2.Press the Multi-function key to reject a call after it rings.
Turn on/off the microphone When you are on a call, lay down the microphone rocker, then the screen shows “MIC MUTE” means the microphone has been turned off. At this moment, the other person can not hear your voice. If you want to come back to the communication state, open up the microphone rocker, then the screen shows “MIC RELEASE” means you can go on to communicate, and the other person can hear you. Over the conversation Just press the End key to over the conversation.
Check the power At the top right corner, there is a prompt sign shows battery power, when it shows no power, please charge in time, or the device will be turned off automatically. Drive at night You’d better turn off the state indicator in case the flashing light affect your attention while driving at night. Press the indicator switch key to change the display state and turn on/off the indicator.
Check the telephone number Note:This function is up to the relative function of your mobile phone, some mobile phones do not support this function, it means they are not compatible with the car kit, but not that the device doesn’t work.
3:Check the missed number After connecting the mobile phone with the car kit , Press the Multi-function key and then press the UP or DOWN key , until the screen shows“Missed Num”, press the Multi-function key again, the screen shows the last missed number. 4:Re-dial the checked telephone number You can press the answer key to re-dial the number which has been checked by these three ways above.
Assemble the backside clip Way 1: Way 2: Fit the Bluetooth hands-free car kit to the sun visor 48
You can fit the car kit to the front or side of the sun visor, but you should make sure the microphone towards to your face. Firstly, you can clip the car kit to sun visor firmly, then unfold the microphone rocker until the screen shows “MIC RELEASE”. Pay attention to the position of the screen and the sight for the driver, it is important for checking the incoming call. Note:Make sure the car kit has been fitted to the sun visor correctly to avoid affect the driver’s sight.
Note:If the disconnection always happens (for example: out of service), the car kit will try to connect again, please do the pair operation if necessary. Using guide for earphone-line Sometimes you want to keep your conversation secret, you can use the original afforded outer earphone, when the earphone is plugged in, the hands-free speaker mutes automatically.
Bluetooth hands-free car kit indicator With charger plug in: Red light on Charging in progress Red light off Charging completes Without charger plug in: No light on Power off Blue light flashes rapidly for 3 times Paired successfully Blue light flashes every 3 seconds(Rapidly flash for 0.1 seconds 6 times then off ) Blue light flashes every 3 seconds(on for 0.5 seconds,off for 2.
Troubleshooting ● While charging, if the red indicator off, please check whether the charger connects well, or the battery power is full or not. If the Bluetooth hands-free car kit can not be connected with the mobile phone. Please do as following: 1. Make sure the car kit has been turned on and paired with the mobile phone. 2. Make sure the Bluetooth function has been startup. 3.
Echo: 1. Adjust the angle of the Microphone rocker. 2. Try your best to make the car kit close to your mouth. 3. Reduce the surrounding noise, such as close the car window or turn down the volume of the car kit sound. 4. If you place the car kit on the instrument, please make it steady. A rubbery pad can be placed between the car kit and the instrument panel to make better effect. 5. The worse signal and communication environment will also cause echo.
Care and Maintenance Your Bluetooth hands-free car kit is a product of superior design and craftsmanship that should be treated with care. The suggestions below will be helpful for your warranty coverage. ● Keep all accessories out of the place that can be reached by little children. ● Keep the device dry. Rain water、humidity and all types of liquid or moisture may contain minerals that will corrode electronic circuits, if your car kit does get wet, please use it after completely air it.
●Do not store the device in the area which is too cold, when the device returns to its normal temperature, moisture will be formed inside the device and damage the electronic circuit board. ●Do not attempt to drop 、knock or shake the device, Rough handling will damage the inside circuit board and the precise structure. ●Do not use the harsh chemicals 、 cleaning solvents or strong detergents to clean the device. ●Do not paint the device, painting may clog the moving parts and prevent proper operation.
Warning: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance will void the user’s authority to operate the equipment. Any change to the equipment will void FCC grant.