Operation Manual

Portable speaker MiFa
Speaker structure
Accesories
USB cable
MIFA speaker
Shackle
Manual
Warranty card
V- Prev.: Short press for previous track, long press for volume
down.
V+ Next.; Short press for next track. long press for volume up.
Incoming calls button. Short press o answer, long press to
deny.
M: Turn-o. Short press to turn on Bluetooth mode,
press twice to enter the SD card mode, press three
times to enter the USB mode, long press for 3
seconds to switch on / o.
Start / Stop. Long press - unpair speaker
from a Bluetooth device, short press - to pair
again.
Blue: blinks: Connect
with Bluetooth, burns
constantly-connected;
Flashes slowly -
pause;
Quickly blinks -
playback mode or
maximum volume.
Red indicator: Blinks when charging is
needed, lights when charges, out when
charged.
Microphone
Interfaces
Reset to factory settings
Turn o the speaker,
insert a SD-card,
connect the speaker to
a computer. You can
then upload the les to a
memory card.
USB sound card Mode. To connect
the speaker with computer, press M.
Now, you can play music from your
computer.
To charge the
battery, connect
an adapter to 5V,
500mA DC or
computer via USB.
Insert an SD-card, press M button to
enter the card mode to play music.
Pairing with other device via Bluetooth
Turn on the power. After
the beep, and the phrase
«Bluetooth enabled», the
blue indicator light starts to
ash. The device is ready
to communicate with your
smartphone.
On the smartphone nd MiFa
F1 device and connect to
it. The default password is
0000.
Speaker will connect with familiar devices automaticaly. To
unbind speaker from device, long press the Start / Stop button.
And only after that pair it with another device.
Characteristics
Type of device
Speaker system
Controls
Features
Memory
Power
Charger
Ouput power
Freq range
Bluetooth
USB
Formats
Portable Bluetooth speaker
Mono
Active
Button
One button control, handless control,
Bluetooth connection, SD-card, USB
sound card mode, card reader.
to 32 GB ash card support
1100 mAh battery
5V 500 mA adaptor, USB connection
3 W, 4 Ohm
80 - 18 000 Hz
2.1 +EDR
USB 2.0, support USB 1.1
ape, ac, wma, wav, mp3
FAQ
1. MiFa F1 speaker is not connected to a Bluetooth device.
Reset the speaker. When asked, set password 0000.
2. Playbaqck stucks.
Check Bluetooth connection, range (to 10 m.), reset speaker if
needed.
3. File format is not supported.
Check type of the SD-card le system (supports FAT32). Also
check music le formats. Speaker supports ape, ac, wma, wav,
mp3 les with any bitrate.
4. Indicator shows connection is on, but music is no playing.
Check a volume of speaker, or play and pause mode.
XIAOMI-MI.COM