80 Series Printer User Manual
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Catalogue I. Product Introduction .......................................................................................................... 3 1.1 Warnings: ....................................................................................................................... 3 1.2 Notice ............................................................................................................................. 3 II. Summary ..................................................................................
I. Product Introduction 80 series printer is a POS direct thermal receipt printer with easy operation and high cost effective, which is widely used in supermarket, hospital, restaurant, bank, oil station, turnpike etc. Safety Notice Please read carefully and strict compliance with use of following instructions before operating the printer. 1.1 Warnings: Warning: Do not touch the cutter of printer.
(9) In order to ensure the printing quality and extend the life of printer, please use the recommendatory thermal paper or the one which has the same quality. (10) Please make sure the power of printer is off when plugging the connecting line. (11) Please keep the user manual for reference when needed. II.
UP Interface: USB+Parallel(25PIN) USB Parallel Cash Drawer Power Supply Cash Drawer Control:6 lines RJ-11 socket,output: DC24V/1A ● Character ASCII code character set:12×24 dots,1.25(W)×3.00(H)mm Chinese character:24×24 dots,3.00(W)×3.00(H)mm International Code page: 10 types of international language--- PC437、 Katakana、PC850、PC860、PC863、PC865、WPC1252、 PC866、PC852、 PC858 and so on.
(4) It would result the fading of thermal paper if to use the hard material to chafe the surface. (5) Please pay attention to the temperature, humidity and illumination of the storage for thermal paper. The paper would fade if the storage temperature is over 70 centigrade. 6 ● (MCBFM)Mechanical reliability: 6×10 lines ● Emulation: ESC/POS Print Font:Support ANK. The font could be magnified, bolded or underlined and the user also could adjust the character spacing before printing.
Printer Power supplier Paper roll CD Power cord Communication cable 4.2 Printer Connection (1) To ensure the printer and PC is powered off and then insert the matched data connection lines to the interfaces (USB/Parallel/Serial) of the printer, the other ends are to the PC. (2) If the user fit out the electric opened cash drawer for the printer that could insert the RJ-11 connection line of it to the corresponding interface of the printer.
(1) Firstly, insert the power supply plug DC24V of printer; then connect the AC220V power; lastly, turn on the switch. Please operate it by the instruction steps; otherwise, it would damage the printer. (2) Using unsuitable power adapter would cause the bad print result; even may cause the breakdown of printer. (3) Do not connect the telephone line to the interface of cash drawer; because it may result in the damage for printer and telephone. (4) Do not pull the power soft wire when unplugging.
(3) Pull a part of paper out and then close the top cover.
V. Power Switch, Keystroke and Indicator Light 5.1 Power Switch Switch is for turning on/off the power supply of printer which is located on the left. When pressing “-”, the printer turns on and when pressing “O”, it turns off. Notice: Do not turn on the switch unless the user connects the power supply. 5.2 Keystroke and Indicator Light Keystroke and indicator board is shown as below: FEED Key: In the standby status, the printer would be continuous feed when pressing the feed key.
3 Printing density High density Regular density 4 24 bytes mode No Chinese Character With Chinese Character 5 Character per line 42 48 6 Select cash box Open cash box Close cash box Transmission rate(apply for serial interface) (refer to below information) 7-8 Transmission rate(bps)-bytes/s SW-7 SW-8 38400 ON ON 115200 OFF ON 9600 ON OFF 19200 OFF OFF 5.
5.5.2 Beeper and light alarm function When the paper still remains after the printing finished, the printer can detect the data via opt coupler and remind the current status with beeper and light alarm. Currently only printers with beeper and light alarm function can support this function, other types of printers can't. This function is no need manually set. VI. Cash Drawer Interface Cash drawer interface adopt RJ-11 standard, 6 lines socket and it outputs DC 24V/1A.
Procedure of maintaining the print head is listed below: (1) Turn off the power supply and open the top cover. Remove the paper if necessary. (2) Please wait for the cooling of print head if it just finishes printing. (3) Use the cotton cloth and dip it in the absolute ethyl alcohol to clean the surface of print head. (4) When the absolute ethyl alcohol is completely volatilized, please close the top cover and restart the printer. 7.
Notice: (1) The power supply of printer should be turned off when the routine maintenance. (2) Do not use hand or metal to touch the surface of print head and not use tweezers to scratch the superficies of print head, print roll or sensor. (3) Do not use oil or acetone to do the maintenance. (4) When the absolute ethyl alcohol is completed volatilized, then turn on the power to print. VIII.
9.2 The indicator light is on, while the printer can’t work Do the self-checking to check whether the printer can work normally. If not, please contact the distributor or technical support. If the self-checking can work, please check the following contents: (1) Check the interfaces of printer and computer and also check whether the connected line between them is to their specification requirement. (2) The setting of data transmission between printer and computer may be different.