1
TWS Bluetooth Hearing Aid is compatible with both IOS and Android operating systems , the true Bluetooth connection and binaural interconnection , which can realize intelligent and free switching in listening to music, making calls, and hearing aids.
……………………………………… ………………………… …………………………………… ………………………… … ………………… …………………………………… ………………………… ……………………………………… …………………………………… ……… 3
1.Product name: TWS bluetooth hearing aid 2.Designed for: Air coduction amplifier for moderate hearing impaired people 3.
Install ear tips: It is important that the tube and the dome fifit correctly into your ear. Choose the right size.
1、Power on / off Push 3 seconds on“upper volume button”to turn on / off the hearing aid. it flashes the green light to turn on, accompanied by (power on) voice prompt; flash the blue light to turn off, accompanied by (power off) voice prompt.
3、Volumes adjustments One short touch to volume up button , it will increase the volume accompanied with two beeps voice prompt , one short touch to volume down button , the voice is decreased accompanied two beeps , if only 1 beep ,means volume reach its maximum or minimum.
b、Turn on the Bluetooth of the mobile phone, pair "iEarton II", click and connect, the pairing is successful, accompanied by (connected) voice prompt. c、Press and hold the “volume up button” of the other hearing aid for 3 seconds to turn it on, the binaural connection is successful, and accompanied by (dong) voice prompt. d、In the Bluetooth connection mode, that is, in the hearing aid function mode.
5、Charging a、When charger plug in, its red light will light up, then thehearing aid can be put in for charging ; the hearing aid will light up in blue when charging, and will turn off when it is fully charged. Then pick up hearing aids, it will flash green once to indicate that it is automatically turned on. b、Before charging , pleasure turn off hearing aids and then put it into the charger for charging , It takes about 2 hours to be fully charged .
6、Flight mode Pleasure turn off the Bluetooth function on your mobile phone when in an airplaine, or anyplace warned to do so, then hearing aids will enter the airplane mode state after 10 seconds.
sound tube microphone volume up domes Volume down indicator light motion lock receiver charging contact thimble 11
1、Put the hearing aid behind the ear; 2、Gently pinch the earbud with your index finger and thumb and carefully insert it into the ear canal (Note: If it is difficult to insert the earplug, you can use theother hand to gently pull the earlobe, which in turn makes the ear canal open wider so that the earbuds fit into the ear canal); 3、Place the motion lock in the concha cavity.
、 、 、 2 1 3 13
、 、 、 14
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2)This device must accept any interference received, including interference that may cause undesired operation.
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.