PRODUCT SPECIFICATION WiFi module WPC0GR2231 Specification IEEE 802.11a/b/g/n/ ac Wi-Fi Module (Realtek RTL8196cd+ RTL8192er+ RTL8812ar) Custom Approval Section Custom Name Department Approval Xiamen Prima Technology Inc Date： DESIGN CHECK APPROVAL Jason yu Guan hui York Chen 2015.03.23 2015.03.23 2015.03.23 Version 1.
PRODUCTS SPECIFICATION WPC0GR2231 Document revision history Revision Version 1.0 Date 2015-03-23 Approved by Jason yu PAGE 2 Remarks Draft OF 10 Version 1.
PRODUCTS SPECIFICATION 1 WPC0GR2231 General Description WPC0G2231 is to specify the product requirements for 802.11 a/b/g/n/ ac Wi-Fi Module. This Module is based on Realtek RTL8198CD+RTL8192ER+RTL8812AR chipset .that complied with IEEE 802.11n 、 IEEE 802.11ac,and it is also backward complied with IEEE 802.11b/g standard from 2.4~2.5GHz.It can be used to provide up to 54Mbps for IEEE 802.11a, 11Mbps for IEEE 802.11b, 54Mbps for IEEE 802.11g, 300Mbps for IEEE 802.11n and 866.7Mbps for IEEE 802.
PRODUCTS SPECIFICATION WPC0GR2231 3. Application Diagrams 3.1 Functional Block Diagram RTL8198CD+RTL8192ER+RTL8812AR Figure 1 3.2 General Requirements 3.2.1 IEEE 802.11b Section Feature Detailed Description 3.2.1.1 3.2.1.2 3.2.1.3 Standard Radio and Modulation Schemes Operating Frequency 3.2.1.4 Channel Numbers 3.2.1.5 Data Rate Media Access Protocol 3.2.1.6 3.2.1.7 3.2.1.8 Transmitter Output Power at Antenna Connector Receiver Sensitivity at Antenna Connector ● IEEE 802.
PRODUCTS SPECIFICATION WPC0GR2231 3.2.2 IEEE 802.11g Section Feature Detailed Description 3.2.2.1 3.2.2.2 3.2.2.3 Standard Radio and Modulation Type Operating Frequency 3.2.2.4 Channel Numbers 3.2.2.5 Data Rate Media Access Protocol 3.2.2.6 ● IEEE 802.11g ● QPSK , BPSK , 16QAM ,64QAM with OFDM ● 2412 ～ 2462MHz ISM band ● ● ● ● 11 channels for United States 13 channels for Europe Countries 13 channels for Japan 6,9,12,18,24,36,48,54Mbps ● CSMA/CA with ACK ● 3.2.2.
PRODUCTS SPECIFICATION +12 dBm at 24,36Mbps +11 dBm at 48,54Mbps Typical Sensitivity at each RF chain. Frame(1000-byte PDUs)Error Rate<10% at room Temp 25 degree C -82 dBm at 6Mbps -81 dBm at 9Mbps -79 dBm at 12Mbps -77 dBm at 18Mbps -74 dBm at 24Mbps -70 dBm at 36Mbps -66 dBm at 48Mbps -65 dBm at 54Mbps ● ● ● 3.2.3.8 Receiver Sensitivity at Antenna Connector WPC0GR2231 ● ● ● ● ● ● ● ● 3.2.4 IEEE 802.11n Section 3.2.4.1 3.2.4.2 3.2.4.3 Feature Detailed Description Standard ● IEEE 802.
PRODUCTS SPECIFICATION WPC0GR2231 5GHz Band/HT40 5GHz Band/HT20 ● -82dBm at MCS0 ● -79dBm at MCS0 ● -79dBm at MCS1 ● -76dBm at MCS1 ● -77dBm at MCS2 ● -74dBm at MCS2 ● -74dBm at MCS3 ● -71dBm at MCS3 ● -70dBm at MCS4 ● -67dBm at MCS4 ● -66dBm at MCS5 ● -63dBm at MCS5 ● -65dBm at MCS6 ● -62dBm at MCS6 ● -64dBm at MCS7 ● -61dBm at MCS7 3.2.5 IEEE 802.11ac Section 3.2.5.1 3.2.5.2 Feature Standard Radio and Modulation Type 3.2.5.3 Operating Frequency 3.2.5.
PRODUCTS SPECIFICATION WPC0GR2231 5GHz Band / HT80 not enabled 4. ● -76dBm at MCS0 ● -73dBm at MCS1 ● -71dBm at MCS2 ● -68dBm at MCS3 ● -64dBm at MCS4 ● -60dBm at MCS5 ● -59dBm at MCS6 ● -58dBm at MCS7 ● -55dBm at MCS8 ● -51dBm at MCS9 Electrical and Thermal Characteristics 4.1 General Section Feature Detailed Description 4.1.1 Antenna Type ● External antenna 4.1.2 Operating Voltage ● 12V±10% 4.1.
PRODUCTS SPECIFICATION WPC0GR2231 4.4 Mechanical Requirements 4.4.1 4.4.2 4.4.3 Feature Length Width Height Detailed Description ● 130mm ● 105mm ● 23mm 4.5 Mechanical Dimensions * TOLERANCES ARE +/-0.5mm UNLESS OTHERWISE SPECIFIED * UNITE :mm 4.6 Connector Pin Definitions 5-Pin 1.
PRODUCTS SPECIFICATION PIN 25 Definition PIN 26 27 LAN A- LAN D- LAN A+ LAN D+ （LAN口PIN2） （LAN口PIN7） （LAN口PIN1） （LAN口PIN8） 31 32 33 34 Definition LAN GND RX*N PIN 28 37 Definition LAN 29 30 GND GND 35 36 GND LAN RX*P WPC0GR2231 LAN GND TX*N 38 39 40 41 42 GND GND GND LAN1 LAN2 LED LED TX*P PIN 43 44 45 46 47 48 Definition WAN 5G WAN GND RST GND LED（Y） LED LED（G） PIN 49 50 51 52 53 54 Definition WPS GND GND GND UART RX GND PIN
FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
When OEG purchase the module, they can only buy this antenna to match the modules The max antenna gain of antenna is 2dBi.
