A/0 Xiamen New Sound Technology Co,. Ltd Address:No.
Contents Preface..................................................................................................1 Features................................................................................................4 Preparation............................................................................................5 Operation..............................................................................................6 How to charge your hearing instrument ..........................................
Preface THANK YOU and WELCOME to NewSound’s most innovative and reliable product, designed to enhance the quality of sounds in your everyday life! This user manual only applies to the Poco SA801 In-the-ear (ITE) hearing instrument Intended use This hearing instrument is an electronic device which amplifies sounds from the surrounding environment. It will help people with mild to moderate hearing loss or those who just want to enhance their ability to hear conversations in a noisy environment.
Features i i Dome Product Safety – relevant product handling and care 4 Contact point 5 Do not drop hearing device onto a hard surface that can damage the instrument. 6 Memory switch 2 1 USB cable Proper disposal of electronic products protects the health of people and the environment. This symbol means the hearing instrument may not be thrown away as normal daily waste. Hearing instrument should be disposed at intended electronic waste/recycle sites, or at your hearing care professional office.
Operation Preparation Kit Packaging included: Poco SA801 device (1) Charing system (1) Cleaning brush (1) Multifunctional screwdriver (1) Memory foam set (size: S, M, L) User manual (1) How to Charge your hearing instrument Closed domes (size: 9mm, 12mm, 15mm) Magic dome (size: 10mm, 12mm) 2 Step 2: Connect the cable with charging base Battery helpful tips 1. A full charge takes about 3.5 hours, and will allow up to 16 hours of use. 2.
Charging steps: 1. Once connected successfully, the charging process begins, and the green indication light will SHINES GREEN. 2. The charging process will complete after 3 hours of charging, and the green indication light will be SOLID GREEN. 3. After 15 minutes’ break, the case will start drying process. The blue indication light will SHINE BLUE, and the green light will keep solid green. 4.
ON and OFF function Remove your hearing aid from the charging slot and hold the Program Button for 3-5 seconds until the unit turns ON. There will be a 3 second delay from the time the unit turns on until it amplifies sound, so that you can avoid feedback while setting it in your ear. To turn your hearing aid OFF, hold down on the Program Button again for 3-5 seconds. Your hearing aid will also turn OFF automatically when you return it to the charging slot.
Maintenance Memory switch Your hearing instrument can be programmed up to 4 different listening programs. When the hearing instrument is turned ON, it will automatically be in last setting. Other preset programs are for your specific needs that can be accessed by pressing the multi-function switch which will change program according to the preset sequence: 1, 2, 3 and 4. Your hearing instrument ‘beeping’ signal will help identity preset programs.
Cleaning care and precautions SYMPTOM Sound: distorted, unclear, intermittent, too much bass, static Too much **Bass Static **Noise 13 POSSIBLE CAUSE SOLUTIONS Low or dead battery Recharge the instrument Sound outlet blocked or damaged Clean sound outlet or contact hearing healthcare professional May need reprogramming Contact hearing healthcare professional Too close to other electromagnetic devices/fields (such as other cell phones, speakers, etc.
Whistling noise helpful tips Whistling is common in small amplifier and is known as 'feedback'. It is caused by amplified sound leaving the ear and receiving back into the microphone and being re-amplified. The following tips will help reduce the effect of feedback/whistle noise: 1. Reduce the volume. Keep volume at lower setting before inserting the instrument in your ear. 2.
5. Why the device is not working during the charging phase? The instrument will turn OFF automatically to allow faster charging cycle. It is recommended the hearing instrument should turn OFF when not in use to prevent the battery from complete discharged and the unwanted feedback noise. 6. How to maintain the hearing instrument charging system? To maximize the internal battery usage, it is recommended that the hearing instrument is charged, typically overnight, on a daily basis.
FDA information Good health practice requires that a person with a hearing loss to have a medical evaluation by a licensed physician (preferably a physician who specializes in diseases of the ear) before purchasing a hearing aid. Licensed physicians who specialize in diseases of the ear are often referred to as otolaryngologists, otologists or otorhinolaryngologists.
* Visible congenital or traumatic deformity of the ear. * Unilateral hearing loss of sudden or recent onset within the previous 90 days. * History of active drainage from the ear within the previous 90 days. * Audiometric air-bone gap equal to or greater than 15 decibels at 500 hertz (Hz), 1000Hz, and 2000 Hz. * History of sudden or rapidly progressive hearing loss within the previous 90 days. * Visible evidence of significant cerumen accumulation or a foreign body in the ear canal.
FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Service and warranty Please ask your hearing instrument/care provider, where you purchased your hearing instrument, about the term of the product warranty and service coverage with/without warranty. DO NOT send your instrument directly to the manufacturer for product service or replacement. Prolinx GmbH Brehmstr. 56, 40239 Duesseldorf Germany Manufacturer Xiamen NewSound Technology Co.,Ltd Address:No.