Installation Instructions

ManualsBrandsXiamen Hualian ELECTRONICS ManualsElectronicsKION China Connect Unit

KCCU-20 instruction

1. Working voltage

Nominal voltage: 12V to 80V

Working voltage range: 8.4V to 104V

2. Connector information

Part No. of connector(Male)

Part No. of counterpart(Female)

Part No. of metal terminal

AMP-Nr 1-966846-1

1563502-1

1418884-1

3. Connector pins definition

Pins

Function definition

Remark

Power supply

Normally from battery

No function

Normally is the battery negative

GND

Analog input 01

Analog input 02

No function

Key input

No function

CAN2-GND

Insulated and without 120Ωresistor in parallel

CAN2-High

CAN2-Low

CAN1-High

CAN1-Low

4. Application function summary

➢ GNSS (GPS + BDS )

➢ RTC (the backup power supply using super capacitor)

➢ 4G communication

➢ 2 CAN bus. one of them is insulated.

➢ 3D acceleration sensor inside.

➢ Using KION cloud server.

FCC Statement

Changes or modifications not expressly approved by the party responsible for compliance could

void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment

KION China Connect Unit

Summary of content (2 pages)

PAGE 1
KION China Connect Unit KCCU-20 instruction 1. Working voltage Nominal voltage: Working voltage range: 12V to 80V 8.4V to 104V 2. Connector information Part No. of connector(Male) Part No. of counterpart(Female) Part No. of metal terminal AMP-Nr 1-966846-1 1563502-1 1418884-1 3.
PAGE 2
off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help This device complies with part 15 of the FCC rules.