Galaxy Instruction Manual Model No. Galaxy-Crown Before operating this unit, please read these instructions completely.
Contents Before Use Safely Precautions rear 1-3 « FCC Radiation Exposure Statement 3 Chair COMPONENTS ..uu over irrepressible sinner tenner rears anon 4-5 = Bluetooth Speaker 4 Setting up the massage chair 8 Preparation before Use... 7-8 How to Use Operation instruction After massage 10-1 Q&A / Important Cleaning and maintenance senses 13 Troubleshooting «coon rr ree earn Grounding Instructions Specifications Thank you for purchasing this Massage Chair.
Safety Precautions When using the massage char, sable precautions should always be followed to reduce the risk of electric shock, burns, fire or injury to persons. Please read the following precautions before using the massage chair. e Make sure the power plug is securely inserted into a proper electrical outlet fo reduce the risk of short-circuit and fire. « it is highly recommended that a surge protector is used to prevent from damage.
® Please consult your doctor if you are in doubt as to whether or not you should use this massage chair. e Please consult a doctor before using the massage chair if you are pregnant, undergoing any medical treatment, using a medical electronic device such as a pacemaker, or are experiencing any of the following: Malignant tumor, heart disease, back pain, abnormal or curved back bone, osteoporosis or acute illness.
FCC Radiation Exposures Statement FCC Radiation Exposure Statement: (mobile device) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, Human proximity to the antenna shall not be less than 20cm (8 inches} during normal operation. FCC STATEMENT 1. This device complies with Part 15 of the FCC Rules.
Chair Components Bluetooth Speaker Pillow Pad Backrest Pad Controller { Waist air bag Seat rest Side panel/Ammrest Footrest A} Bluetooth Speaker NOTE: The Bluetooth speaker can only connects with one Bluetooth device at a time. Please tum off your Bluetooth device after using so that other users can enjoy it as well. The Bluetooth name label! is on the right side of power switch on the electric control box.
Setting up the massage chair @ Make sure there is enough space for the tilting of the product. € Do not expose the product to direct sunlight or a high-temperature places in front of heating equipment; otherwise its synthetic leather may fade or harden. # Place a mal below the product to avoid floor damages. The mat should cover the product's area in contact with the floor and the footrest's area in contact with the floor (minimum dimensions: 80"X32" }. Ses the figure.
Preparation before Use Make sure thees Is no prison, pet either object close 1a the prods Back cushion Roll up the back cushion and fix it on the main body by the zipper. Make sure there is no foreign matter in the seams of the product. When checking the Lower Leg/Foot massage section, press the footrest Backrest forward by your hands and make sure there is no foreign matter in the seam. © Do not past hands, fin , Tut or head Into the seam(s) between footrest and the seat surface of the armrests.
inspect the power line and power plug /N\ Warning ® Remove such dirt as dust on the power plug at regular intervals. Otherwise fires caused by poor insulation due to factors such as moisture may happen. (ips the power plug with dry cloth.) ® Do not damages the power ins of the power plug.
sure massage Inspected area: The fabric of traveling sections of the massage wheels on the backrest # Boors use, check whether fabrics of the area pointed out in the figure are damaged.
Operation Instruction Note: The default time for all massage functions is minutes. The chair will be off after 15 min's use. Tum on the power, and pass the power switch on the bosom of the massage chair farms fo "I" position, Massage chair in a reset state At this point the massage chair into the standby mode. In Standby mode only backrest incline / recline and ON / OFF can be operate. Massage are not available .
4. Speed, Strength, Air Pressure Intensity { * Width } When the chair is operating, short press this button to start increase the speed, strength and air pressure intensity. Every ime this button is pressed, the level will change from LV1 > LV2 > L¥3 in cycles * When the chair is operating in manual mode, long press 2 second to adjust the massage roller width. Vary time long pressed this button the width elev! will sangs from narrow > medium > width binnacle 5.
Afire massage Power off the product. (D Turn off the power switch. @ Pull out the power plug. @ After uss aah time, pull the power switch io the © positional pull out the power plug; weatherize accidents and injuries by playing with them by children may happen. 12 The Lower Leg/Foot massage section will remain at the final position. The massage wheels will move to the retracting positions. The backrest will not muse automatically.
Cleaning and maintenance Wipe the synthetic leather with a soft dry cloth. Do not clan the product with chemicals such as When using a leather maintenance product {cleaning cloth) sold on the market, follow its directions for use. 24 the synthetic leather is very dirty, wipe it with the method below. Put a pace of soft cloth nits water neutral def argent contained hot water and wring i out.
Troubleshooting "After a fault happens, inspect and try the corresponding method below. iH the fault still exists after that, contact the shop from which you bought the product. F alehouse and elimination method Bp iis ‘and suntans on tha revision Rule sd Lisa’ iid bb Fido Ted ET ® Uproar ne Belle lied EE en plug has abnormal heating.
" You will hear or have the following sounds or feelings when using the product. lt is not abnormal phenomena but results of the product structure.
Grounding Instructions This product must be grounded. If it should malfunction or break down, grounding provides a path of least resistance for the electric current to reduce the risk of electric shock. This product is equipped with a cord with an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance with all local codes and ordinances.
Specifications Power supply 110~120V, 50/60Hz Power consumption S0W Default timer minim Dimensions(L Upright: Approx. Recline: Approx. Weight Approx. 102ibs Package dimensions(L x Wx H}) Approx.