Certification Exhibit FCC ID: VEYXMODR1 FCC Rule Part: 15.247 ACS Project: 13-2019 Manufacturer: xG Technology, Inc. Model: xMod User Manual 3998 FAU Blvd.
xMod Users Manual
xMod 2.5 User Manual Table of Contents Introduction........................................................................................................................................... 3 Box Contents.......................................................................................................................................... 3 Hardware Overview..............................................................................................................................
xMod 2.5 User Manual Introduction The xMax xMod device is a wired/wireless bridge between xMax and 802.11 protocols. Its primary function is to allow Ethernet or WiFi enabled devices to connect to an xMax network. This manual provides basic setup and operational instructions for the xMod unit. Box Contents The xMod device is shipped with the following items. xMod Device AC Adaptor Ethernet Cable USB to USB Micro Cable Hardware Overview The xMod device is a self contained 802.
xMod 2.5 User Manual The xMod device has 2 LEDs, a status LED and Power LED. The definition of the LED states is listed below. Power LED Solid Green- Device Powered Status LED Solid Green- Registered with system Flashing Green- Registering Orange- No xMax signal Red- Device Fault Configuring the xMod for the First Time • • • • • • • • • • Connect the power cord to the AC adaptor. Plug the AC adaptor into the barrel connector on the xMod device.
xMod 2.5 User Manual Using a WiFi enabled device, configured for DHCP operation, connect to the SSID that was configured in the previous step. When connected you are able to begin data operations like web browsing.
xMod 2.5 User Manual Safety Notices • • • Read, follow, and keep these instructions. Heed all warnings. Only use attachments/accessories specified by the manufacturer. Electrical Safety Information • Compliance is required with respect to voltage, frequency, and current requirements indicated on the manufacturer’s label. • Connection to a different power source than those specified may result in improper operation, damage to the equipment or pose a fire hazard if the limitations are not followed.
xMod 2.5 User Manual RF Exposure “This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.” Warning: Changes or modifications to this device not expressly approved by xG Technology could void the user’s authority to operate the equipment.
xMod 2.5 User Manual Because it is impossible for xG to know the purposes for which the purchaser acquired this Product or the uses to which this Product will be put, the purchaser assumes full responsibility for the selection of the Product for its installation and use.