Xeta2m-T User Manual September 29, 2015
Table of Contents Warranty ............................................................................................................................. 1 FCC Notifications ................................................................................................................. 2 1.1 Performance ....................................................................................................... 4 Specifications ...................................................................................
Warranty XetaWave LLC warrants your XetaWave wireless data transceiver against defects in materials and manufacturing for a period of two years from the date of purchase. In the event of a product failure due to materials or workmanship, XetaWave will, at its discretion, repair or replace the product. In no event will XetaWave LLC, its suppliers or its licensors, be liable for any damages arising from the use of or the inability to use this product.
FCC Notifications Federal Communications Commission This device complies with Title 47 CFR § Parts 1, 15, 90 of the federal code. Specifically, 47CFR § 1.1310, Table 1, Limits for General Population/Uncontrolled Exposure. This device must be operated as supplied by XetaWave LLC. Any changes or modifications made to the device without the express written approval of XetaWave LLC may void the user’s authority to operate the device, pose violations and liabilities.
WARNING These radio systems shall be installed by a RF/radio professional familiar with the applicable rules. Installation of all antennas shall be performed in a manner that will provide at least the MPE Distance from the direction of maximum radiation, to any user or member of the public and consistent with the settings in the applicable antenna installation compliance section below. FCC antenna compliance Since professional installation is required, standard RF connectors are used.
To calculate safe distance: Equation 2: MPED ConductedPower(mW )DutyCycle AntennaGain 4 ExposureLimt (mW / cm 2 Where: MPED is Maximum Permissible Exposure Distance or safe distance. All quantities are calculated in linear or numeric quantities. The exposure limit, MPED, and conducted power units must be consistent, mW and cm for this case. Duty cycle is set using packet sizes for master and slave. Packet sizes are set in the radio Network Configuration Menu.
Frequency Stability: Duty Cycle: Output Impedance: Better than 1.0 ppm Continuous 50 Ohms Receiver **ALL SENSITIVITIES ARE TBD** 217-220MHz 220-222 MHz 12.5 kHz 25 kHz 50 kHz MSK 9.6 kbps 18 kbps 43 kbps QPSK 17 kbps 29 kbps 72 kbps 8PSK 26 kbps 44 kbps 105 kbps 16PSK 36 kbps 59 kbps 144 kbps 32PSK 45 kbps 76 kbps 180 kbps 15 kHz 50 kHz MSK 8.
1.4 Mechanical / Physical Design 1.5 Configuration The following parameters are available for selection by the installer at the end-product level for all products that incorporate the Xeta2m-T: - Frequency (Master and Slave) Modulation Type The installer shall set the frequency (or pair of frequencies) according to the requirements of the user’s license. There are different modulations and bandwidths available. The available modulations are limited to those listed in paragraph 1.
further limited by frequency selection. A modulation shall be selected according to the bandwidth (channel size and number of channels) that is specified in the user’s license. Lower speeds have generally better sensitivity and longer range, while higher speeds offer greater data throughput. 1.6 Password The installer shall set a password for the end-product to prevent alteration of the radio parameters by unauthorized parties.