XETA7-M2 User Manual
Table of Contents Warranty ............................................................................................................................. 1 FCC Notifications .................................................................................................................
Warranty XetaWave LLC warrants your XetaWave wireless data transceiver against defects in materials and manufacturing for a period of two years from the date of purchase. In the event of a product failure due to materials or workmanship, XetaWave will, at its discretion, repair or replace the product. In no event will XetaWave LLC, its suppliers or its licensors, be liable for any damages arising from the use of or the inability to use this product.
FCC Notifications Federal Communications Commission This device complies with Title 47 CFR § Part 27 of the federal code. Specifically, 47CFR § 1.1310, Table 1, Limits for General Population/Uncontrolled Exposure. This device must be operated as supplied by XetaWave LLC. Any changes or modifications made to the device without the express written approval of XetaWave LLC may void the user’s authority to operate the device, pose violations and liabilities.
Integration FCC ID: When the module is installed inside of another device, then the outside of the device into which the module is installed must display a label referring to the enclosed module. The exterior label will use the wording: ‘Contains FCC ID: PEJ-9382009’ Serial # X00000000 1234 1234 Model # XETA7-M2 Contains FCC ID: PEJ-9382009 Input Voltage: 12.
WARNING These radio systems shall be installed by a RF/radio professional familiar with the applicable rules. Installation of all antennas shall be performed in a manner that will provide at least the MPE Distance from the direction of maximum radiation, to any user or member of the public and consistent with the settings in the applicable antenna installation compliance section below. FCC antenna compliance Since professional installation is required, standard RF connectors are used.
To calculate safe distance: ConductedPower DutyCycle AntennaGain 4 ExposureLimit MPED Where: MPED is Maximum Permissible Exposure Distance or safe distance in cm; ConductedPower is the power delivered to antenna input in mW; ExposureLimit is a limit for General Population/ Uncontrolled exposure in mW/cm2 All quantities are calculated in linear or numeric quantities. Duty cycle is set using packet sizes for master and slave. Packet sizes are set in the radio Network Configuration Menu.
6