User's Manual

Description
The Multi-technology Readers feature a rugged design and
can be installed almost anywhere. Durable, weatherproof,
UV-resistant materials, along with advanced electronics
and circuitry, protect readers against inclement weather
and exposure to sunlight.
Mounting the Reader
1. Find a suitable mounting position on the door frame or wall.
Note: For out of doors or wet locations, it is recommended
that the gasket provided be installed on the base as shown
in Figure 2.
2. Drill two mounting holes a minimum of 3.25” (82.6 cm)
apart on the mounting surface of the door frame or wall.
Refer to Figure 3.
3. Drill one .625” (1.587 cm) diameter hole in wall for the
pigtail wire connection.
4. Follow the cable connection chart. Connect power at the
panel when installation is complete.
5. Mount the base plate to the wall using the supplied screws.
6. Install gasket if required, see Figure 2.
7. Install top cover straight on to the reader base. Do not
force the cover on. The four cover guides should ensure
the connector seats correctly.
8. Verify the connection is secure and install the security
screws at the top and bottom of the reader.
9. Place a screw head cover over each of the screws. The
screw head cover should be flush with the reader once in
place.
5.850 [148.6]
1.160
[29.5]
1.750
[44.5]
front view side view
XceedID Corporation
3899 Hancock Expressway
Security, CO 80911
Tel: [phone]
Fax: [phone]
www.xceedid.com
Multi-technology Readers
Installation Guide
Figure 1. Multi-technology Readers
Figure 2. Gasket Installation
Figure 3.
Figure 4. Aligning base plate and top cover