User's Manual

XceedID : Document No: 0093-01; Issue No. 1; 10/18/04
INSTALLATION SHEET
XF1100, XF2100, XF2110
PARTS LIST:
• 1 - Installation Sheet
• 1 - Reader
• 2 - Mounting Screws
• 1 - Security Screw (2 w/XF2100 and XF2110)
Removal:
1. Remove unit from box.
2. Notice the connector on the inside of the cover plastic and the base unit plastic. The
connector will end up at the top side of the reader when mounted. (ILLUSTRATION)
Mounting the Reader:
1. Determine an appropriate mounting position on the door frame or wall, be sure to
account for any applicable ADA height requirements.
2. Drill a minimum of two mounting holes a minimum of 3.2” apart on the mounting surface
of the door frame or wall. Drill one 3/4” diameter cable hole for the pigtail wire
connection. Wire the unit according to the color code chart below. Screw base unit to
wall. (ILLUSTRATION)
3. Following cable connection (see the cable connection diagram below), re-install the
plastic cover to the reader base. The base male connectors should align with the cover
connector holes and the bottom slot should easily slide over and snap into place over
the plastic dimple of the base. After ensuring connection, install the security screw on
the bottom of the reader.
Cable Connections:
1. XceedID readers are supplied with a 12 conductor cable pigtail. Connect this pigtail with
the host/panel being careful to match the color of each wire with the chart shown below.
(ILLUSTRATION)
Yellow = Beeper
Blue = Hold
Purple = Open Collector/Card present
Green = Data 0
White = Data 1
Orange = Green LED
Brown = Red LED
Red = Power +DC (6-16 VDC)
Black = Ground
Pink = RQE (Request to Exit input)
Grey = DI (Door DI Input)
Tan = Tamper Output
Drain = Shield Ground