User's Manual

XceedID : Document No: 0225-01; Issue No. 1; 6/23/2005
INSTALLATION SHEET
XF1060
PARTS LIST:
• 1 - Installation Sheet
• 1 - Mounting Plate
• 1 - Potted Reader Assembly
• 1 - Cover
• 2 - Mounting Screws
• 1 - Assembly Screw
Removal:
1. Remove unit from box.
Mounting the Reader:
1. Determine an appropriate mounting position on the door frame or wall, be sure to
account for any applicable ADA height requirements.
2. Drill a minimum of two mounting holes a minimum of 1.35” apart on the mounting surface
of the door frame or wall. Drill one 3/4” diameter cable hole for the pigtail wire
connection. Wire the unit according to the color code chart below. Screw mounting plate
to wall. (ILLUSTRATION)
3. Following cable connection (see the cable connection diagram below), re-install the
plastic cover to the reader base. The base male connectors should align with the cover
connector holes and the bottom slot should easily slide over and snap into place over
the plastic dimple of the base. After ensuring connection, install the security screw on
the bottom of the reader.
Cable Connections:
1. XceedID XF1060 readers are supplied with an 8 conductor cable pigtail. Connect this
pigtail with the host/panel being careful to match the color of each wire with the chart
shown below.
(ILLUSTRATION)
Blue = Beeper
Green = Data 0
White = Data 1
Orange = Green LED
Brown = Red LED
Red = Power +DC (5-16 VDC)
Black = Ground
Drain = Shield Ground
Note: If Hold function is desired, it can be assigned to any of the Brown, Orange or
Blue wires in lieu of the function above.
2. Use a DC power source between 5 volts and 16 volts.