User's Manual

ManualsBrandsXAVi Technologies ManualsElectronicsWireless module

W224Z0 WiFi IoE Module Page 1 of 12



 ProductSpecification



W224Z0

WirelessModule



W224Z0isahost‐lessIoESmartNetworkmodulethatenableswirelessinternet

connectivityforanydevicewishingtobemonitoredormanagedremotely.The

W224Z0isarchitectedforhighperformance,feature‐richapplications.Thismodule

isbasedonQCA4531,ahighlyintegratedandfeature‐richIEEE802.11n2x22.4GHz

System‐on‐a‐Chip(SoC).ExternalDDR2andSPIflashmemoriesareprovidedthat

supportabigvarietyofapplications.Twoantennaportsareavailableforflexibleuse

ofexternalantennasfortheappliancesinconsideration.



1. ProductFeatures

 2.412‐2.484GHzforworldwidemarket.

 IEEE802.11noneandtwostreamsradio.

 Fullsecuritysupport:WPS,WPA,WPA2,WAPI,WEP,TKIP.

 On‐boardmemories:64MBDDR2and1x4MbitNOR+1GbitNANDSPIFlash

 Hostinterfaces:UART,I2C,GPIO,USB,andEthernet.

 ROMAPIsupport.



Summary of content (12 pages)

PAGE 1
W224Z0 WiFi IoE Module Page 1 of 12 Product Specification W224Z0 Wireless Module W224Z0 is a host‐less IoE Smart Network module that enables wireless internet connectivity for any device wishing to be monitored or managed remotely. The W224Z0 is architected for high performance, feature‐rich applications. This module is based on QCA4531, a highly integrated and feature‐rich IEEE 802.11n 2x2 2.4GHz System‐on‐a‐Chip (SoC).
PAGE 2
W224Z0 WiFi IoE Module Page 2 of 12 2. General Specification Product Specification Model Name 1 Solution(HDK version) Qualcomm SoC QCA4531/CUS531‐030 (DP25‐Y9614‐1) design. Form factor Pin header module Moisture sensitivity level MSL:3 (follow IC specification) WLAN Standard IEEE 802.11 b/g/n Host interface UART, I2C, GPIO, USB, Ethernet Antenna configuration 1 or 2 antennas Dimensions Antenna Connector W224Z0 Minimum Typical Maximum Unit Length 44.7 45 45.3 mm Width 34.
PAGE 3
W224Z0 WiFi IoE Module Page 3 of 12 Operating Condition Operation voltage Operation temperature Operation temperature (Full load) Operation temperature (Low rate≤ 10Mbps, IOT) Humidity Non‐Operating Minimum Typical Maximum Unit DC 3.15 3.3 3.
PAGE 4
W224Z0 WiFi IoE Module Page 4 of 12 3. Connector Pin‐out Definitions Pin definitions of J3 Pin No.
PAGE 5
W224Z0 WiFi IoE Module Page 5 of 12 4 RST_B I/O Configurable interface pin 5 UART_SOUT I/O Configurable interface pin 6 UART_SIN_HERDER UART_SIN I/O Configurable interface pin 7 USB_DP I/O USB D+ signal 8 USB_DM I/O USB D‐ signal 9 GND 10 AVDD20 11 P4_TX‐ I/O Configurable interface pin 12 P4_TX+ I/O Configurable interface pin 13 P4_RX‐ I/O Configurable interface pin 14 P4_RX+ Note: NP = No Place I/O Configurable interface pin Ground
PAGE 6
W224Z0 WiFi IoE Module 4. Packing information 4.1 Tray size: 4.
PAGE 7
W224Z0 WiFi IoE Module 4.3 Carton size: 328mm x 249mm x 188mm There are 9 trays in one carton (180pcs one carton) 4.
PAGE 8
W224Z0 WiFi IoE Module Page 8 of 12 FCC Notice Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 9
W224Z0 WiFi IoE Module Page 9 of 12 configuration, the FCC radiation exposure limits set forth for an population/uncontrolled environment can be satisfied. Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. USERS MANUAL OF THE END PRODUCT: In the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna while this end product is installed and operated.
PAGE 10
W224Z0 WiFi IoE Module Page 10 of 12 IC Notice This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence.
PAGE 11
W224Z0 WiFi IoE Module Page 11 of 12 population/uncontrolled environment can be satisfied. Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. USERS MANUAL OF THE END PRODUCT: In the user manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna while this end product is installed and operated.
PAGE 12
W224Z0 WiFi IoE Module Page 12 of 12 低功率射頻模組警語 (1) 「經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能」。 (2) 「低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾」。 (3) 「本模組於取得認證後將依規定於模組本體標示審驗合格標籤, 並要求平台廠商於平台上標示「本產品內含射頻模組 CC XX xx LP yyy Z z」。