User's Manual

Lamp Dimmer Installation notes
The Lamp dimmer is designed to work with all incandescent (Tungsten loads) of up to
300W.
Plug the unit in the wall outlet.
Plug the lamp in the module
Use the tethered device to control the lamp brightness
Lamp and Wall Dimmer User Operation The dimmer dongle is used to manually
adjust and control lighting. There are two buttons on the dongle. The button with the
raised bump is the lights on or ramp brightness level up control. This raised button has a
red back light to aid location of the buttons in the dark. The button with the lowered
bump is the lights off or ramp brightness level down control. This button will is also
backlit at a lower level. When power is applied to the dimmer, the dimmer level will
default to the full on state.
Pressing and holding the lights off button will ramp the light level down to off.
Pressing and holding the lights on button will ramp the light level to full on. The light
level set by pressing and holding either of these two buttons is the user's set level and will
be remembered by the dimmer.
If the user presses the lights off button, using a quick tap, the light level will be set to full
off.
If the user presses the lights on button, using a quick tap, the light level will be set to the
last user's set level or 16% brightness using the brighter of these levels.
The dimmer has a delayed off feature. This allows the light to be set on, then after a
period of time, the light will be turned turn off. This is useful, at night, if the light control
is located far from the room exit or as a sleep setting for reading in bed. To activate this
feature press and hold either button and tap the other. The dimmer will beep and the light
level will be set to the 50% brightness level if it was below the 50% level originally. The
default on time will be 5 minutes. When this on time expires, the brightness level will be
slowly ramped down to full off.
During the on time, the brightness level may be changed, without disturbing the delayed
off timer, by using the press and hold method to adjust the brightness level.
The delayed turn off function has a snooze mode. This is activated by pressing either
button during the slow off ramp. When the snooze mode is activated the brightness level
will be ramped back to the original level and the delayed off timer will be restarted for
another delayed turn off cycle.
The delayed turn off function can be canceled if either button is tapped during the on time
interval.