User's Manual

2
I
OneLink Bridge Set Up/Discovey
Please use the following directions to install and configure your OneLink Bridge.
1. To Power unit, connect transformer to OneLink Bridge and then plug transformer
into wall outlet (120VAC).
2. Log into your Remote Account and got to the Discovery page of the Account Settings
section. Press the “Start Discovery” button on the Discovery page.
3. Once the Discovery process has begun, press the Discovery button on the OneLink Bridge.
Note: You only have 2 minutes once the Bridge enters into the Discovery mode.
4. Once the Discovery process has finished for the OneLink Bridge, it will appear on the list of
your devices on the Discovery page.
OneLink Device Discovery
1. While you are in Discovery mode the top light will be flashing.
2. Press down the test button on any one of the OneLink Alarms in your system, until
the flashing LED on the OneLink bridge stops flashing.
3. When you are finished discovering devices, press “Stop Discovery” and click “Device Overview”.
4. At a later date, if you wish to add additional OneLink Alarms devices to your system, simply
log into your Remote Account and go to the Discovery page of the Account Settings section;
press the “Start Discovery” button on the Discovery page and repeat steps 2 and 3 above.
This Device Complies With Part 15 of The FCC Rules.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC NOTE:
THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED
BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD
VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.
START DISCOVERY
ONELINK BRIDGE DISCOVERED
DISCOVERY IN PROGRESS
ONELINK TEST BUTTON
DC POWER
DISCOVERY BUTTON